Subaru 1600 Service Manual page 660

6. Roof Trim
I) Detach trim, weatherstrip clips,
etc. as necessary.
a. Front pillar (upper) trim
b. Center pillar upper trim
c. Rear pillar lower trim after remov-
ing rear seat back rest
d. Rear pillar upper trim
e. Roof side rail trim
f. Rear rail
g. (Hatchback)· Weatherstrip only at
upper edge of side window
NOTE:
Almost all trim is fixed
with
plastic
dips. Remove clips with Puller 92558-
0000.
3) Detach inner rear view mirror, sun
visor, sun visor hook, assist rail, room
lamp, etc.
3) (Sedan and Hardtop) Remove
front windshield glass. (Others) Pull
out front edge of roof trim from lip of
windshield weatherstrip.
4) Take out roof trim through front
opening (front windshield) or rear gate
or front door opening.
BODY
A24·553
Fig. 14-202 Taking out roof trim
5) Installation can be carried out in
the reverse order of removal.
Torque
Rear view
mirror screw
NOTE:
1.0 - 1.4 N·m
(0.1 - 0.14 kg-m,
0.7 - 1.0 ft-Ib)
Pay careful attention not to catch trim
on electrical wiring.
14-65
7. Side Sill Cover
1) (Sedan and Station Wagon) Detach
rear seat cushion.
2)
(Vehicle with trunk opener)
Pull
knob out of openerlever.
3) Remove hinge cover of front seat.
4) Remove screws, and detach (front
and rear) side sill cover.
NOTE:
Slide front seat appropriately to per·
form this job.
5) Installation can be carried out in
the reverse order of removal, paying
attention to the following.
a. Be careful not to catch it on
electrical wiring or come in contact
with clips of wirings, piping, etc.
b. Make proper alignment of front,
rear and center pillar trim.
c. Use stepped tapping screws except
for the extreme rear end of (rear)
side sill cover where an ordinary
tapping screw and a washer are
fitted. Be sure to use plain washer,
otherwise the screw might sink too
far.