Subaru 1600 Service Manual page 148

4) Assembling Air Horn, and
Bringing Air Horn and Body
Casting Together
1) Install needle seat with fuel filter
and washer.
Needle seat
A8-405
Fig.
4·65
2) Install fuel inlet needle with spring
and needle pin.
1 Fuel inlet needle
2 Spring
3 Needle pin
Fig.
4·66
3) Install float.
1 Float
2 Float hinge pin
Fig.
4·67
4) Check float adjustment.
NOTE:
A8-406
A8·407
Refer to 8 "Check and Adjustment".
FUEL SYSTEM
5) Put air horn gasket on air horn.
Air horn gasket
A8-408
Fig.
4·68
6) Position air horn on body casting
with gasket and tighten seven screws.
~~:;:;;:;:~"
Screw
Fig.
4·69
7) Install connector rod with rod
bushings.
Connector rod
2 Rod bushing
Fig. 4-70
AS-410
5)
Installing Feedback Solenoid
and Bowl Vent Solenoid
1) Put bowl vent annature, spring
retainer and valve together.
I Bowl vent armature
2 Spring retainer
3 Valve
Fig.
4-71
AS-411
2) Put spring and bowl vent armature
assembled in
n
into bowl vent sole-
noid.
(,' @
~
\
\
~
~
I Bowl vent armature
2 Spring
3 Bowl vent solenoid
Fig.
4-72
AS-412
3) Install bowl vent solenoid assem-
bled in 2) with gasket.
Bowl
vent
solenoid
A8-413
Fig. 4-73
4) Install feedback solenoid with
gasket.
AS-414
Fig.
4·74