Subaru 1600 Service Manual page 611

NOTE:
a. The above-mentioned adjustment
should be carried out with a slight
force applied to regulator handle
so as to eliminate free play.
Approx.8.1 mm(Q.319in)
1
~o,~
JL----~
~~
Stopper B
A24·453
Fig. 74-34 Gap adjustment of glass
rear edge
b. Make sure that stopper
A
and B
come in uniform contact with glass
holder.
c. for readjusting the gap at the
top of the glass, carry out
A-1)
and 2). and then 8-1) and 2). If
this order is neglected, the glass
might incline forward, whereby
proper gap won't be obtained.
Wrong
~
I Stopper
2 Glass holder
A24·454
Fig. 14-35 Fixing stopper A and B
3) Make sure that the gap between
door glass and weatherstrip on side
window glass has the same dimension
as shown in the following figure.
If necessary, shift the door glass
frontward or reaward by adjusting
rear sash.
BODY
(Refer to door glass.)
Approx. 8.1 mm (0.319 in)
~ In~Out
Parallel 6
±
2
~
(0.24
±
0.08
in)~
r
~
-
Fig. 14-36 Confirmation of gap
adjustment
A24-455
4) Make sure tha t the gaps at side
window glass are provided in accor-
dance with above figure.
C Check of side window adjustment
1) After adjusting side window glass,
fit roof side weatherstrip securely to
the retainer.
2) Confirm the following items so as
to prevent water leakage or the like
trouble_
a. The whole edge of glass is covered
with the lip of weatherstrip, leav-
ing no clearance.
If there is a clearance, the gap is
inproperly adjusted.
b. No clearance appears by slightly
pushing the glass from the pas-
senger compartment.
If a clearance does, the contact
pressure is insufficiently adjusted.
Slightly pushing
I Weatherstrip retainer
2 Roof side weatherstrip
A24-456
Fig. 14-37 Checking adjustment
14-16
NOTE:
If
the contact pressure is excessive,
erroneous engagement with the weath-
erstrip, abnormal wear, increase in
force needed to operate the regulator
or a similar trouble might be caused.
c. Door glass rear edge does not con-
tact to the shoulder of weather-
strip on side window glass.
If it contacts, the gap is improperly
adjusted.
d. There is no clearance between door
glass and weatherstrip on side win-
dow.
If there is clearance, the contact
pressure is insufficiently adjusted.
Shoulder of weatherstrip
Parallel
1 Weatherstrip on side window
2 Moulding
3 Side window glass
4 Door glass
A24-457
Fig. 14-38 Checking adjustment
e. The weatherstrip on side window
glass is not bent to outside of door
glass upon operating door window
regulator or side window regulator.
If it is the gap or contact pressure
is improperly adjusted_
In Weatherstrip
Door glass on side window glass
Out
A24-458
Fig. 14-39 Bending of weatherstrip
3) After installing sealing cover,
sprash or shower water to make sure
that there is no leakage into the com-
partment.
I,
II