Subaru 1600 Service Manual page 281

MANUAL TRANSMISSION AND DIFFERENTIAL
2. R.mov.1 .nd
DI ••••• mbly
I
Except 4WD
I
1) Gearshift lever knob.
2) Front exhaust pipe.
3)
Removal of gearshift lever ASSY.
a. Neutral set spring
b. Stay (from engine rear mounting
bracket)
c. Rod (from joint)
d. Cushion rubber
4)
Disassembly of gearshift lever
ASSY.
a. Rod from lever
b. Spacer, bushing (rubber) and
bushing (resin) from rod
c. Lever from stay
d. Cushion, bushing, plate and dust
seal from lever
e. Spacer, bushing and cushion rubber
from stay
14WDI
1) Exhaust system.
2) Rod cover, parking brake cover
and tray.
3) Gearshift lever knob.
4)
Nut which connects rod B with
rodA.
5)
Plate from body.
6) Boot and neutral set spring.
7) Separate rod A from transfer rail
of transmission.
NOTE:
Be clreful not to lose bushing.
(except DUII-rlnge)
8) Gearshift lever from lever.
9) Lever from shifter arm by taking
out cotter pin and driving out spring
pin.
10) Dust seal.
11) Disassembly of gearshift lever.
a. Spacer
b. Bushing (resin)
c. Bushing (rubber)
12) Separate plate from drive selector
lever. For dual-range, remove switch
from plate.
13) Remove the parts shown in figure
from drive selector lever.
6-64
1 RodB
2 Wave washer
3 Bushins
.. Washer
Fig. 6-217
S Self-Iockins nut
6 Bushins
(resin)
7 Bushing (rubber)
8
Spacer
A 1111-100
14) Remove the following parts from
rod A as shown in the illustration.
Fig. 6-218
1 RodA
2 Bracket
3 Bush
.. Bush
S Washer
6 Washer
7 Sclf-locking nut
A19-153