Subaru 1600 Service Manual page 730

2. On-car Services
• Adjustment
1) Make sure that wiper operation is
in smooth.
2) When wiper switch is in "OFF"
position, adjust blades in original
position as shown in illustration by
changing wiper arm installation.
A25-351
Fig. 15-196 Adjusting wiper blade
position
3) Adjust washer ejecting point on
windshield glass as shown in illustra-
tion when car stops.
Unit: mm (in)
A25-352
Fig. 15-197 Adjusting washer ejecting
point
• Replacement of Wiper Blade
Rubber
1) While pushing both side claws of
latch toward
@
as shown in the
following illustration, pull out latch
along with rubber and vertebra toward
@.
ELECTRICAL SYSTEM
Primary lever
A
Vertebra
Fig. 15-198
A25-799
2) Install new rubber ASSY (rubber
and vertebra) in the reverse order of
removal.
Latch
Primary lever
Secondary lever
A25-800
Fig. 15-199
NOTE:
a. Make sure the vertebra is securely
held at the lock portions of the
primary lever and secondary lever.
b. Install rubber ASSY properly so
that latch is located as before.
3. Replacement
1) Removal
1) Disconnect both blades from arms
by pulling lever up and sliding them.
A25-340
Fig. 15-200 Disconnecting blade
15-67
2) Pulling up covers of arms, and
take them out.
3) Remove nuts installing arms, and
take out them.
A25-342
Fig. 15-201 Removing nut
4) Open engine hood, disconnect
ground cable from negative terminal
of battery, and disconnect electric
wires from wiper motor at connector.
5)
Remove screws installing cowl
panel and take out it.
6)
Take out links and connection
rod.
A25-014
Fig. 15-202 Taking out links and
connection rod
NOTE:
Prepare a gadget that has same size of
inner diameter as outer diameter of
plastic joint, apply it on plastic joint,
and disconnect rod from wiper motor
by pushing it down to tighten plastic
claws.
7) Remove bolts installing wiper
motor and take out it.
Fig. 15-203 Removing bolts
/
(
\ I
A25-345