Subaru 1600 Service Manual page 808

ELECTRICAL SYSTEM
2) Hazard Warning Light Switch and Turn Signal & Hazard Unit
Hazard lamp does not light.
I
See if fuse #2 (lOA, HAZARD)
Yes I ·1
I
I
Fuse is blown.
Replace fuse.
is blown.
No
.---.
No
I
Check voltage at 0.5G of comb i-
Faulty connector connection be-
Repair connector or ha
nation switch connector.
tween fuse box and combination
Yes
switch, or broken harness wire.
Remove combination switch con-
No
..
Hazard unit defective.
Replace unit or repair ha
nector from switch. See if turn
..
Faulty contact or broken wire
- - - - - - - - - - - - -
mess.
l
_----.J
signal lamp lights by connecting
in harness between hazard unit
0.5G and 0.5GR (RH) of con-
connector (0.85YW and 0.85
nector on harness side or 0.5G
GW) and combination switch.
and 0.5GL (LH).
..
Faulty contact or broken wire
between combination switch
Yes
connector and hazard lamp.
(Connect all turn signal cir-
cuits, and confirm by con-
trolling turn signals.)
-
Turn on hazard switch, and check Hazard switch defective.
I
Replace combination swit
I
conduction between 0.85G and
0.85YW, 0.85GW and 0.85GL,
and 0.85GW and 0.85GR.
15-145