Subaru 1600 Service Manual page 149

6) Installing Idle Stop Solenoid
and Fuel Line
1) Install idle stop solenoid with fuel
line bracket.
I Idle stop solenoid
2 Fuel line bracket
Fig.
4-75
A8·415
2)
Position banjo gasket, banjo fuel
line assembly and second banjo gasket
on air horn.
1 Banjo fuel line assembly
2 Banjo gasket
Fig.
4·76
A8-416
3) Put banjo bolt on banjo fuel line
assembly and tighten lightly.
A8-417
Fig. 4·77
4) Install fuel line clamp (outer) and
fuel line clamp (inner).
FUEL SYSTEM
Fuel line clamp (outer)
2 Fuel line clamp (inner)
Fig.
4·78
A8·418
5) Tigh ten banjo bolt to the specified
torque.
E[
34-40N.m
Torque (3.5 - 4.1 kg·m,
25 - 30 ft·lb)
Fig. 4-79
A8-419
Fig. 4·80
A8-420
7) Install choke vacuum hose.
Fig. 4·81
NOTE:
Choke vacuum
hose
A8·421
Make sure that all the linkages operate
smoothly.
8. Check
and Adjustment
Float Setting
1) Detach the air horn gasket, then
position the float at the air horn.
2) Turn the top side of the air horn
down to free the float. At this pOint,
measure the distance shown in the
figure below.
Fig.
4-82 A8-423
3) If the distance is outside the
specifications, bend portion (A) to
adjust the distance.
4) After the distance has been ad·
justed properly, turn the air horn right
side up to lower the float. Measure the
distance from the lower surface of the
air horn to the tip end of the float to
ensure that it is more than 38 mm
(LSD in); If necessary, bend portion
(B). The needle must be free while
adjusting the distance.
9. Installation
1)
Install carburetor with two gaskets
and an insulator on intake manifold.
2) Install vent hose, connector and
spacer with gasket, and then connect
hoses.
3) Connect accelerator cable to
throttle lever.
4) Connect harness connectors.
5) Connect vacuum hoses.
a. Distributor advance
b. E.G.R.
6) Connect hoses for fuel.
a. Fuel hose
b. Fuel return hose
c. Carburetor air vent hose
7) Install air cleaner.
8) Replenish the coolant.