Subaru 1600 Service Manual page 108

c. When using THREE BOND 1215,
dry the coated surface for 5 to 10
minutes before installation.
d. Remove Valve Lifter Clips
(899804100) before installing oil
pan.
20) Install crankcase oil pan, oil
pan gasket and transmission cover II
(MT).
Torque
(Oil pan)
(SUBARU 1600)
4.4 - 5.4
N'm
(0.45 0.55
kg·m,
3.3 - 4.0 ft·lb)
Fig. 3-169 Installing crankcase hanger
22) Install flywheel with O·ring (MT)
or converter drive plate with back
plate and O-ring (AT) on the crank-
shaft gear.
Apply liquid gasket [THREE
BOND
1215 (pIN 004403007))
to the
threads of the bolts.
~
AT MT
49-53N·m
41-45 N'm
Torque (5.0 - 5.4 kg-m, (4.2 - 4.6 kg-m,
36 - 39 ft-Ib) 30 - 33 ft-Ib)
ENGINE
I Transmission cover II (MT)
2 Oil pan
A5·271
Fig. 3-168 Installing oil pan
21) Install pitching stopper bracket
and crankcase rear hanger, if it has
been removed, to flywheel housing.
On CoW carburetor, install accelerator
cable bracket with hanger.
NOTE:
Do not misplace the washer.
I Nut
2 Bolt
3 Spring washer
4 Crankcase rear hanger
5 Pitching stopper bracket
6 Timing hole hanger
7 Bolt
8 Timing hole hanger
9 Stiffener RH (4WD)
10 Stiffener LH (4WD)
11 Accelerator cable bracket
(C-W carburetor)
NOTE:
A5·693
a. The flywheel or drive plate and
back plate can be installed only in
one position since not all the bolt
holes are positioned at equal
intervals.
b. When installing back plate, align
the mark on back plate and the
hole in drive plate. (AT)
ConV'erter drive plate
2 Hole
3 Mark
4 Back plate
i
A5·353
Fig. 3-170 Installing drive plate and
I' back plate (A
T)
c. When using THREE BOND 1215,
dry the bolts coated with it for 5 to
10 minutes before $l:rewing them
in.
23) Install clutch disc and clutch
cover with bolts and spring washers,
aligning clutch disc with flywheel by
inserting Clutch Disc Guide
(499747000)
into needle bearing fitted
in flywheel. (MT)
Torque 16 N·m
(Clutch cover)
(1.6 kg-m, 12 ft-Ib)
I
r,
Clutch Disc Guide (499747000)
A5-354
Fig. 3-171 Installing clutch cover
NOTE:
Position the clutch cover so that the
"0" marks on the flywheel and clutch
cover are spaced 120
0
or more.
24) Install water pump, hose, pipe
compi. and heater hose as an assembly
and install another hose.