Subaru 1600 Service Manual page 426

I
SUSPENSION, WHEELS AND AXLES
!
I
NOTE:
a. Tighten band until it cannot be
moved by hand.
b. Former Band Tightening Tool
(925090000) is interchangeable
with this 925091000.
A16-201
Fig. 9-91 Installing boot band
15) Tap on the clip with the punch
provided at the end of Band Tighten-
ing Tool.
NOTE:
Tap to an extent that the boot under·
neath is not damaged.
16) Cut off band with an allowance
of about 10 mm (0.39 in) left from
the clip and bend this allowance over
the clip.
17) Fix up boot on C.V.J. in the same
manner.
5. Installation
1) Insert axle shaft into housing and
attach spacer of Installer (925130000)
on outer bearing inner race taking care
not to damage the oil seal lip.
A16-169
Fig. 9-92 Installing axle shaft
2) Connect the rod of Installer to
the thread of axle shaft and turn the
handle while holding the rod end by
means of a spanner, thus axle shaft is
pulled in.
3) Align the spring pin holes of
0.0.1. and differential spindle.
4) Connect 0.0.1. and differential
spindle by driving spring pin in.
NOTE:
a. Make sure that the holes are aligned
before driving the spring pin in.
b. When driving the spring pin, always
use new one.
I
A15·015
Fig. 9-93 Driving spring pin in
5) Connect damper strut to housing,
and tighten two bolts.
Torque
29 - 39 N·m
(3.0 - 4.0 kg·m,
22 - 29 ft.lb)
9-31
-
~-~~
-
-~---
A16~170
Fig. 9-94 Connecting damper strut
6) Install disc cover on housing with
one bolt.
Torque
6 -14N·m
(0.6 - 1.4 kg-m,
4.3 - 10.1 ft·lb)
7) Install hub and disc ASSY to
axle shaft.
Fig. 9-95 Installing disc hub
8) Install or connect disc brake
ASSY, hand brake cable, center piece,
conical spring washer, axle nut, cotter
pin, brake hose, tie rod and transverse
link according to the same procedure
of "9-11 Housing - 4. Installation".
9) Install wheels and tighten wheel
nuts.
1 0) Install wheel caps in position.
11) Put down vehicle from rigid racks.
12) Connect ground cable with nega-
tive terminal of battery.
-~
- -
- -
-
~-
-
- - ~-~
- -
~-~
--.-----
--~---~--~--.~