Subaru 1600 Service Manual page 411

(r--
}
f
'
I
I
SUSPENSION, WHEELS AND AXLES
11) Install washer into oil seal with
facing grinded surface of washer to
lip side of oil seal.
NOTE:
Apply grease on oil seal lip and sliding
surface of washer.
1 Washer
2 Oil seal
3 Thrust washer
4 Piston rod
5 Upper spring seat
A15-100
Fig. 9-31 Installing oil seal etc.
12) Install oil seal and washer assem-
bly on to thrust washer.
NOTE:
Be sure to position oil seal lip to face
to coil spring.
13)
Install
strut mount to piston rod,
and tighten self-locking nut temporar-
ily.
NOTE:
Never use removed self-locking nut,
and replace it with new one.
14) Loosen Puller (included in Puller
& Wrench (925651000)] gradually,
and remove it.
15) Tighten self-locking nut by using
Wrench (included in Puller
&
Wrench
(925651000)] .
Torque
Fig. 9-32
59 -74 N·m
(6.0 - 7.5 kg-m,
43 - 54 ft-lb)
A15-Q84
4. Installation
1) Set strut assembly in position,
and temporarily tighten nuts clamping
strut mount to body.
NOTE:
Take care of installing direction of
strut mount
2) Push and set stru t into housing
gradually and carefully.
3) Tighten two damper strut instal-
ling bolts.
Torque
Bol t installing
29 - 39 N·m
damper strut
(3.0 - 4.0 kg-m,
bracket to
housing
22 -
29 ft-lb)
Bolt clamping
29 - 39 N·m
damper strut
(3.0 - 4.0 kg-m,
to housing
22 -
29 ft-Ib)
A15·083
Fig. 9-33
4) Securely tighten nuts clamping
strut mount to body.
Torque
Fig. 9-34
29-39N·m
(3.0 - 4.0 kg-m,
22 - 29 ft-lb)
A1S-076
9-16
5) Clamp brake hose with clip on
damper strut.
6) Connect brake hose to caliper
body.
Torque
(Union bolt)
NOTE:
15 -
20 N·m
(1.5 - 2.0 kg-m,
11-14ft-lb)
Always be sure to use flare nut wrench.
Fig. 9-35
A15·082
7) Connect brake hose to brake pipe
at apron bracket.
Torque
Fig. 9-36
12-18N·m
(1.2 - 1.8 kg-m,
9 - 13 ft-lb)
o
A15·072
8) Install another side damper strut
in the same manner.
9) Install tires and wheels, and
tighten wheel nuts temporarily.
10) Apply parking brake, and lower
vehicle after taking ou t rigid racks.
11) Tighten wheel nuts.
Torque
(Wheel nut)
78 - 98 N·m
(8.0 - 10.0 kg-m,
58 - 72 ft-lb)
12) Bleed air from brake system.
13) Connect ground cable to negative
terminal of battery.