Subaru 1600 Service Manual page 736

b. Disconnect electric wires and an-
tenna feeder cord.
A25·375
Fig. 15-226
c.
Pull out turning and volume control
knobs.
d. Remove radio mounting nuts.
A25-376
Fig. 15-227 Removing mounting nuts
e. Remove radio mounting screw and
replace radio.
A25-377
Fig. 15-228 Removing mounting
screw
2) Speaker in instrument panel
a. Take out glove box by removing
installing screws.
b. Remove nuts installing speaker and
take out speaker.
c. Disconnect electric wires from
speaker at connector.
ELECTRICAL SYSTEM
3) Speaker on left side of instrument
panel
a. Detach speaker grille with screw-
driver.
b. Remove 3 screws fitting speaker
bracket to instrument panel.
c. Take out speaker along with
bracket, and replace speaker.
4) Antenna
a. Detach antenna feeder cord from
clips inside of instrument panel.
b. Take out front pillar inner trim
through that antenna feeder cord
enters car.
I
A 25-S07
Fig. 15-229 Taking out front pillar
inner trim
c. Remove screws installing mud gard,
tear mud gard off partially, and pull
out antenna feeder cord.
A25-S0S
Fig. 15-230 Removing screws
d. Detach antenna rod.
e. Remove nut and take cover out.
~::Flod
\
~!/
~
,
0"'
Y:-,:-..:..:"""
~
Tightening torque N·m (kg-m, ft-Ib)
T: 3 - 6 (0.3 - 0.6, 2.2 - 4.3)
Fig, 15-231
A25-809
15-73
f. Remove bolt installing antenna
earth cord, and pull antenna down.
Fig. 15-232
• Adjustment
1) Setting push button
Antenna
grounding wire
Feeder cord
A25-S10
There are five push buttons, so five
stations are selected as follows.
a. Select a station by turning the
turning dial.
b. Pull the push button and push it
back, and then the push button is
kept set at the station required.
OM-742
Fig. 15-233 Setting push button
NOTE:
•. Confirm the push button is set It
the center of the channel, otherwise
the tone becomes bad according to
an amount of discrepancy from the
center of the channel.
b. For FM/AM radio, push the FM
push button once before selecting
FM station.
2) Adjusting antenna trimmer
Antenna trimmer is adjusted in order
to make each radiosensitive in case
the sensitivity is poor or abnormal
noise exists (AM band only).