Subaru 1600 Service Manual page 749

ELECT'UCAL SYSTEM
• Vehicle with CARTER·WEBER carburetor
Operation
Three cables connect to the drums in
the link ASSY.
• Cable A from accelerator pedal-+
Upper drum
• Cable B from carburetor -+ Center
drum
• Cable C from actuator -+ Lower
drum
1) When the cruise control is not
activated, depressing the accelerator
pedal causes the carburetor to operate
through the sequential movement of
cable A, center drum and cable B.
To carburetor 0
Fig. 15·267
To accelerator
pedal
Cross sactional view
2) When the cruise control is acti-
vated, operation of the actuator is
transmitted through cable C, lower
drum, center drum and cable B, thus
activating the carburetor.
3) After the cruise control has been
set, depressing the accelerator pedal
activates cable A, upper drum, center
drum and cable B, in that order,
regardless of the operation of the
actuator, thus activating the carbu-
retor.
Link ASSY
To actuator
Cable B
To carburator
0--=«,... ...
Tightening torque N·m (legem, ft·lb)
T: 2·6(0.2·0.6,1.4·4.3)
16-86
Adjustment
1) Loosen nuts. Adjust the piay of
the cable A so that the upper drum
begins to operate when the cable's
axial play is less than 2 mm (0.08 in).
Tighten nuts.
2) Adjust the axial play of the cable
B at the carburetor until the play is
within 0 to 2 mm (0 to 0.08 in).
3) Adjust the axial play of the cable
C until the lower drum begins to
operate when the play is less than
2 mm (0.08 in). After the axial play is
adjusted, tighten nuts connecting the
cable to the actuator.
Actuator
ASSY
(Bulkheadl
Cable
A
: / (Spare tire)
I
To accelerator
A25·821
J
1
I
j
J
1