Subaru 1600 Service Manual page 641

BODY
4. Trunk Lid
B
A
\
c
DETAIL B
1 Trunk lid complete
2 Weatherstrip
"V''',/@
"......
.
<
i
DETAIL A
Fig. 14-149
• Torsion Bar
1) Open trunk lid and remove tor-
sion bar at opposite end of hinge.
2) Remove torsion bar end hooking
up with trunk lid hinge.
NOTE:
Care should be taken that when the
torsion bar is removed from the hinge,
hood might drop down with its dead
weight
3)
Remove torsion bar from bracket
at its center.
4) Attach (new) torsion bar as be-
fore.
NOTE:
a. Apply grease to the contact area of
roller and hinge.
b .. Since left and right torsion bars are
different, don't misuse them.
• Trunk Lid Opener
1) Take out puilliandle knob by pull-
ing forward.
2) Release cable from the following
parts.
a. Trunk lid lock
3 Hinge assembly
4 Roller
5 Torsion bar
6 Torsion bar
7 Trunk opener knob
8 Trunk opener handle
9 Trunk opener cable
10 Lock assembly
11 Clip
12 Key lock assembly
A24-313
b. Clamp on right-hand hinge
c. Clips and tapes after removing rear
seat, front seat hinge cover and side
sill cover
d. Puilliandle
NOTE:
Be careful not to kink cable.
3) Remove pullhandle from cross-
member.
4) Install puilliandle with screw.
A24-320
Fig. 14-150
14-46
5) Connect cable to pullhandle.
A24-319
Fig. 14-151
6) Fix cable as before with clips and
tapes, and install rear seat, front seat
hinge cover and side sill cover.
NOTE:
Renew all clips and tapes.
7) Connect cable to right-hand hinge
with clamp.
8) Connect cable to trunk lid lock.
9) Insert knob to puilliandle.
• Weatherstrip
Attach the trunk room weatherstrip
by pushing it down from the upper
side so as to be attached to the
surrounding in position.
NOTE:
Set weatherstrip so that its juncture
comes to the center of rear skirt (rear
panel of trunk room).
•
•
\0
o
o
A24-321
Fig. 14-152 Installing weatherstrip
~".I
.
,j -,' _""""""'" ......
eo ."
>II '
- . . " " , - j ..... , - , _ , . . . ,
---_,-------.1_1----__ ----______ ---