Subaru 1600 Service Manual page 250

MANUAL TRANSMISSION AND DIFFERENTIAL
I
No. Parts Inspection Corrective action
(3) Damaged inner surface or tooth
Replace.
surface.
(4) Unusual wear or uneven wear on
Replace.
ring inner surface.
4 Synchronizer hub and
(1) Excessive wear into steps on hub Replace.
insert spline or excessive wear on hub
end face.
(2)
Deformed or excessive worn hub
Replace.
inserts.
(3) Any other problems.
Replace.
5
Bushing and race
(1) Damage or unusual wear on slid·
Replace.
ing part.
(2)
Unusual wear on the inner face. Replace.
6
Oil seal (I) Damage, hardening and excessive
Replace.
i
wear on the lip.
(2)
Any other problems.
Replace.
7
O-ring (I) Deformation, hardening, damage
Replace.
!
or excessive wear on seal surface.
(2)
Any other problems. Replace.
S Gear shift mechanism (I) Damage, excessive wear or bend.
Correct or replace.
(2)
Any other problems.
Correct or replace.
9
Differential gear (1) Damaged, excessively worn or Replace.
seized tooth surfaces of crown
gear and drive pinion.
(2)
Excessively worn or damaged Replace.
roller bearing contact surface of
drive pinion.
(3) Damaged, worn or seized differen· Correct or replace.
I
tial pinion, side gear, washer
(35.1 x
45
x
t), differential pinion
i
shaft and straight pin.
i
(4) Cracked, worn or damaged differ- Correct or replace.
L
ential case.
I
(5) Excessively worn or damaged axle
Correct or replace.
drive shaft journals contacting the
differential case.
6-33