Subaru 1600 Service Manual page 278

MANUAL TRANSMISSION AND DIFFERENTIAL
A4-105
A4-096
Fig. 6-211 Tightening bolts and nuts
16) Adjust pitching stopper as follows:
a. Loosen nut until pitching stopper
on bracket (on the engine side) is
free to move.
b. Tighten rear nut until the rubber
cushion-to·washer clearance is with·
in specified value.
Specified clearance
0.8 - 1.2 mm (0.031 - 0.047 in)
c. Attach a wrench to rear nut, and
tighten front nut securely.
Torque
10-
18N·m
(1.0 - 1.8 kg-m,
7 - 13 ft-lb)
A4·113
Fig.
6-212
Adjusting pitching stopper
17) Connect speedometer cable to
transmission, and tighten it hard with
your fingers. Then, using pliers, re-
tighten cable by approximately 30°.
A4-116
A4·117
Fig. 6-213 Connecting spe8CIometer
18) Route speedometer cable under-
neath pitching stopper with battery
cable, and clamp it on pitching
stopper.
19) Make all necessary wiring connec-
tions.
NOTE:
Be sure to connect the ground cable.
20) Connect clutch cable and adjust
the free play of cable.
21)
On
4WD,
connect both the
4WD
selector system and gearshift system
with transmission as follows:
a. Insert gearshift lever into dust seal,
and connect gearshift lever with
lever.
(Use new self-locking nut.)
Torque
(Self-
locking nut)
14 - 22 N'm
(1.4 - 2.2 kg-m,
10 - 16 ft-Ib)
6-61
NOTE:
Insert the
dun
sell upper end into the
groove of galnhift leVlr firmly_
b. Insert rod A into boot, and fix boot
to body.
c. Install rod B and drive selector lever
to plate.
(Use new self-locking nuts.)
Torque
(Self-
locking nut)
14 - 22N·m
(1.4 - 2.2 kg-m,
10 - 16 ft-Ib)
d. Connect rod A with rod
B
by
tightening nut while holding rod A
with a wrench.
Torque
(Nut)
Fig.
6-214
48
-49
N·m
(4.9 - 5.0 kg-m,
35 - 36 ft-lb)
A19-l07
e. Install rod cover.
f. Install hand brake cover, and then
hand brake tray cover.
22) Connect battery ground cable.
23) Check the transmission oil level
and, if necessary, add oil.
24) Start engine. Check exhaust pipe
connections to ensure there is no gas
leakage.
25) Check the operation of clutch for
smooth engagement and disengage-
ment.
26) Check the operation of shift lever
or select lever for smooth gearshifting.
27) After all work has been com-
pleted, install spare tire.