Subaru 1600 Service Manual page 621

BODY
• Adjustment of Door Lock Mechanism
No. Symptom Possible cause
Measure
I Door won't be opened by outer
Play of adjust nut is excessive. Readjust the play to 0.5 - 1.0 mm
handle (but opened by inner handle.)
(0.020 - 0.039 in)
2 Door won't be opened by inner
a. Connection of rod (upper side) is
• Tighten securely.
handle (but opened by outer handle).
loose.
b. Child lock lever of rear door is
• No particular measure is required.
shifted to LOCK. (Unlock lever)
3
Door won't be opened by unlocking
a. Not unlocked due to poor adjust-
• Loosen the screw connecting the
inner remote (on both inner and
ment of inner remote position. rod (upper side) and adjust the
outer handles).
(Red mark is seen considerably remote position. (Install with the
even by locking.) latch side lever pushed forward
and lock lever of inner remote
touched with the stopper.)
See Fig. 14-79.
b. Connection of rod (lower side)
• Connect it securely with holder
is loose. similarly to above
See Fig. 14-79.
c. Unlocking status won't be attained
• The same as No.1
because adjust nut depresses lever
See Fig. 14-80.
4 Door is opened although inner
a. Lock is not applied due to poor
• The same as No. 3-a
remote is in lock position.
adjustment of inner remote.
See Fig. 14-79.
(Keyless lock won't operate.)
b. Connection of rod (lower side)
• The same as No. 3-b
is loose. See Fig. 14-79.
5 Child lock lever won't be moved
a. Inner handle does not return com-
• See No.6.
upward.
pletely.
b. Poor adjustment of rod (upper
• Readjust (Connect with child
side) (It is connected to be
lock lever shifted to LOCK
pulling connector) and latch connector depressed)
See Fig. 14-79.
6
Inner handle stops halfway. Rod (upper side) is in close contact Bend rod (upper side) so as to
with inner remote bracket. eliminate contact
See Fig. 14-78.
14-26
c'~'·4'·""..o--~""'.....\I;.
....
~,
............... , ..... _. _ _ _ _ , ... , """...,.. _ _ _ _ _ _ _ _ - -_ _ _ - -_ _ _ _ _ _ _ _ _ _ - -