Subaru 1600 Service Manual page 101

1 Valve rokcer ASSY (R.H.)
2 Snap ring
3 Nut
4 Washer
5 Valve rocker screw
6 Rocker shaft spring washer
7 Rocker shaft supporter
8 Valve rocker arm CP
9 Rocker shaft spacer
10 Valve rocker shaft
Fig.
3· 134
Assembling valve rocker parts
4. Cylinder Head
1) Press oil seal onto intake valve
guide. Refer to 3-7,4.
NOTE:
Apply oil to the oil seal prior to
pressing.
ENGINE
11 Valve rocker arm CP 2
12 Valve rocker ASSY (L.H.)
13 Valve rocker ASSY (R.H.)
14 Rocker shaft spacer
15 Valve rocker shaft
16 Valve rocker
17 Valve rocker arm
18 Valve rocker arm 2
19 Lock washer (only for
hydraulic valve lifter)
NOTE:
A5·692
a. Take care not to damage the lips of
the intake valve oil seals when
installing the intake valves.
b. Place the inner and outer valve
springs with the paint mark toward
the valve spring retainer, or with
the close coil side toward the cyl-
inder head.
2) Apply oil to stems of intake and
exhaust valves prior to installation.
3) Install intake and exhaust valves
with inner and outer valve springs,
'valve spring retainers and retainer
keys on cylinder head by using Valve
Spring Press (899724100).
1 Outer valve spring 4 Valve spring retainer
2 Inner valve spring 5 Valve stem
c. After installing all the parts, tap the
spring top lightly with a plastic
hammer or the like to give better
seating of the valve.
3 Retainer key
A5·324
Fig.3-135 Installing valve and related
parts
3-64