Subaru 1600 Service Manual page 248

MANUAL TRANSMISSION AND DIFFERENTIAL
5) Roller bearing with Puller ASSY
included in Puller Set (899524100),
and Seat (399520105).
A 12'()38
Fig. 6-58
4) Transmission Rear Case
Assembly
(
Other than 4WD
& )
4WD Dual-range
1) Fillers, gaskets, springs and balls.
NOTE:
There is no spring and ball in the lower
filler hole for 4-speed.
2) Plug, gasket, reverse accent shaft
and reverse return spring.
3)
Back-up light switch.
5) Transfer Case Assembly
(14WD & 4WD Dual-range
I )
1) Shifter
arm.
2) Filler, gasket, reverse accent spring
and ball.
3) Plug, gasket, reverse accent shaft
and
spring.
4) Snap ring with screwdriver or the
like.
5) Strike out needle bearing with an
aluminum rod.
6) Back-up light switch.
6) Extension Assembly
(14WD & 4WD Dual-range
I )
1) Snap ring (inner 72) from exten-
sion with screwdriver or the like.
2) Punch out rear drive shaft with a
hammer and an aluminum rod.
Aluminum rod
Fig. 6-59
3)
Lock nut-18 with Holder (89988-
4100) and Socket Wrench (89998-
8608).
NOTE:
a. Raise the staked portion before
rotating the lock nut.
b. Shift sleeve into drive position.
A12·227
Fig. 6-60
4) Remove the following parts with
Remover (899864100) and Retainer
(899714110).
• Ball bearing
• Thrust plate
• Transfer driven gear
• Bushing
• Sleeve and hub
• Spacer
• Ball bearing
1 Remover (899864100)
2 Retainer (899714110)
Fig. 6-61
6-31
A12·228
7)
Input Shaft Complete
( !
4WD Dual-range
I )
1) Oil guide and input shaft holder
shim.
NOTE:
The quantity of selective shim is 0 to
2 sheets.
2) Wind vinyl tape on the spline of
input shaft.
3) Snap ring (IN-56) with Pliers
(398663600).
//
~Iier
13986636001
Fig. 6-62
A12·348
4) Take out input shaft by tapping
the shaft end with plastic luunmer,
while holding input shaft holder.
Fig.
6-63
1 Input shaft bolder
2 Input shaft
5) Snap ring (Outer), input shaft
retainer and input shaft cotter.
6) Ball bearing with Remover II
(899858600).
Fig. 6-64
A12-351