Subaru 1600 Service Manual page 431

r
9) Install rear brake assembly to
inner arm, and connect brake pipes
etc.
A16183
Fig. 9-114
10) Connect brake hose and brake
pipe.
11) Temporarily fit brake drum,
center piece, washer spring and castle
nut to spindle in this order.
NOTE:
a. Play on spindle experienced, when
mounting brake drum is not a fault.
b. Don't confuse orientation of washer
spring.
~.~
cD®@@
~ aint mark
Nut. • Center piece
side side
Washer spring
1 Cotter pin
2 Castle nut
3 Washer spring
4 Center piece
A16-197
Fig. 9-116 Installing castle nut
SUSPENSION, WHEELS AND AXLES
12) Bleed brake system.
NOTE:
a. Before bleeding brake system,
check pedal play and brake fluid
level in reserve tank.
b. Bleed air from four wheels without
fail.
13) Tighten castle nut, insert cotter
pin and bend it firmly with foot
brake applied to lock the wheel and
axle.
NOTE:
After tightening castle nut to the spec-
ified torque, tighten further within
30° to align holes on nut and spindle.
14) Install packing to differential
spindle.
15) Engage 0.0.1. of rear drive
shaft to differential spindle.
NOTE:
a. When mounting, mate the spline
teeth properlv so that the D.O.J.
and spindle spring pin hole will
align.
b. When mounting the rear drive
shaft assemblv, take care not to
mount the inner D.O.J. and outer
D.O.J. oppositely.
9-36
Inner D.O.J.
Outer D.O.J.
A16-106
70.5mm
++If--+-+(2.776 in)
dia.
A16·107.
Fig.9-117 Inner and outer D.O.J.
16) Install packing to rear spindle,
and mount 0.0.1. on rear drive shaft
onto spindle with trailing arm lowered
all the way.
A16·189
Fig. 9-118 Installing D.O.J. and
spindle
17) Drive spring pins in to inner and
outer D.O.l.s respectively.
NOTE:
a. Before driving in the spring pin,
confirm alignment of the holes.
b. Be sure to renew the spring pin to
be driven in.
I, _1 ' .
,~
...
~4"""""""'~.'''''_'~''·,~_·'''112
...
·~
...
tt" - .... ,
,.1_ . . . · . . . . . . . . · . . . . .
",51_, ... , .... """' " __ , ' ' ' _ ' ________ -''''"-_______ - -___ -''"''''' ____ _
; I I
1t •
F: •