Differential Gear Oil (Automatic Transmission); Rear Differential Gear Oil (4Wd Vehicle) - Subaru 1600 Service Manual

PERIODIC MAINTENANCE SERVICES
• Replacing
1) Drain fluid by removing drain
plug.
Fig. 2-30
OM·335
2) Reinstall drain plug after draining
fluid, and tighten it to the specified
torque.
25N·m
(2.5 kg·m, 18 ft-Ib)
Torque
NOTE:
a. Be sure
to
place a gasket between
oil pan and drain plug.
b. Replace the gasket with new one.
3) Fill A TF through the fluid level
gauge hole.
Capacity
5.6 6.02
Non4WDAT
( 5.9 - 6.3
US
qt )
i
4.9 5.3 Imp qt
I
6.0 6.42
:1
4WDAT
( 6.3 - 6.8
US
qt )
J
I
5.3 - 5.6 Imp qt
NOTE:
When replacing A TF, the normal
refilling capacity
is
4.02 (4.2 US
qt,
3.5 Imp qt).
4) Check the ATF level according to
the above inspection procedure 1) to
6).
17. Differential Gear
Oil (Automatic
Transmission)
• Inspecting
Oil
level should be maintained be-
tween two points on the level gauge. If
the oil level is at lower point or below,
add some oil up to upper point.
Fig. 2-37
OM-516
• Replacing
I) Drain oil by removing drain
plug.
OM-747
Fig.
2-32
2) Reinstall drain plug after draining
oil, then tighten it to the specified
torque.
Torque
25N·m
(2.5 kg·m, 18 ft·lb)
NOTE:
a. Be sure to place a gasket betlNeen
the differential gear case and the
drain plug.
b. Replace the gasket with new one.
2-11
..
-.---.~
I
3) Fill differential gear oil through
the oil level gauge hole up to upper
point on the level gauge.
I
Capacity
l.H
(1.3
US
qt )
1.1 Imp qt
18. Rear Differential
Gear Oil (4WD
Vehicle)
• Inspecting
Remove plug of ftller hole and check
the oil level. Oil level should be
maintained fully to the mouth of filler
hole.
If the oil level is below the mouth of
filler hole, add some oil up to the
mouth.
OM-517
Fig.
2-33
• Replacing
1) Drain oil by remOVing drain plug_
2) After installing drain plug onto
rear differential gear case firmly, fill
oil up fully to the mouth of ftller hole.
I
Capacity
0.8
Q
(0.8 US
qt )
0.7 Imp qt
3) Install ftller hole plug onto rear
differen tial v;ear case firmly.