Subaru 1600 Service Manual page 655

7) Engage the lock at the rear of
cushion with the hook mounted to the
body floor.
8) Install the two hinge assemblies
at the front of cushion onto the
vertical wall of the body rear floor
by four 6 mm bolts.
I
5.4 - 9.3 N'm
I
Torque (0.55 - 0.95 kg-m,
4.0 - 6.9 ft-lb)
~-.~~------------~
BODY
3) Adjustment
After installing the cushion and back
rest, make sure that each lock is
engaged completely.
If not, make adjustment in the follow-
ing manner.
1)
Cushion lock
Make adjustment in the following
order.
a. Adjust setting of hook to body.
b. Adjust setting of lock assembly
to cushion pan.
c. Adjust setting of hinge to cushion
pan.
d. Adjust setting of hinge to body.
14-60
'" t
2) Hooks on both sides of back rest.
a. If proper engagement is not ob·
tained vertically (the rod at the
front of the striker does not come
to the center of notched hole in the
hook cover of the back rest),
make adjustment by tapping the
tip of the striker with a rubber
hammer or the like.
b. If proper engagement is not ob-
tained in the direction of body
width (the hook does not engage
striker properly because end bar
interferes engagement), make ad-
justment by placing washer on the
setting surface to the body.