Subaru 1600 Service Manual page 413

2. Installation
I) Set crossmember along with steer-
ing gear box in position and carefully
support them with a jack.
NOTE:
Check crossmember for cracks and/or
damage, and replace it if necessary.
2) Lower engine assembly by operat-
ing chain block.
3) Tighten self-locking nuts connect-
ing steering torque rod and pinion
shaft.
Torque
Fig. 9-38
----_._
...
_---]
14 -- 20 N·m
(1.4 - 2.0 kg-m,
10 -- 14 ft-Ib) . .
A15-104
9·6. Ball Joint
A15-161
Fig. 941
1. Removal
1) Jack up body at the front to
remove wheels.
SUSPENSION, WHEELS AND AXLES
4) Tighten nuts attaching engine
mount cushion rubber to crossmem-
ber.
20-32N.n~J
(2.0 -- 3.3 kg-m,
14 -- 24 ft-Ib)
-----~ ---~--.--
Fig. 9-39
A15·103
5) Connect transverse link to cross-
member by temporarily tightening
nuts for transverse link bushing.
Fig. 9-40
A15-077
2) Remove cotter pin, castle nut and
bolt to remove ball joint.
2. Installation
1) Install ball joint onto housing.
Torque
(Bolt)
NOTE:
29 - 39 N·m
(3.0 - 4.0 kg-m,
22 - 29 ft-Ib)
a. Pay attention not to stick grease
to tapered portion of ban stud.
9-18
6) Install front exhaust pipe.
7) Connect tie-rod end to knuckle
arm of housing.
Torque
(Castle nut)
25 - 49 N·m
(2.5- 5.0 kg-m,
18 - 36 ft-lb)
8) Connect parking brake cable
bracket to transverse link.
9)
Attach air cleaner assembly and
pitching stopper rod.
10) Install front tires and wheels.
11) Apply parking brake and lower
vehicle to the ground.
12) Tighten nut connecting trans-
verse link to crossmember to the
specified torque.
[ :---1
~J
59 - 69 N·m
Torque (6.0 - 7.0 kg-m,
43 - 51 ft-Ib)
- ' -
- _ . _ - - - - - - -
13) Connect ground cable to negative
terminal of battery.
b. The ban joint and boot that have
been removed must be checked for
wear, damage or crack, and any
defective part must be replaced.
2) Connect ball joint to transverse
link.
Torque
(Castle nut)
39 N·m
(4.0 kg-m, 29 ft-lb)
3) Retighten castle nut further until
a slot in castle nut is aligned with the
hole in ball stud end, then insert new
cotter pin and bend it around castle
nut.-
4) Install front wheels, and lower
vehicle.
~
..
'O:.;;.4.-'~_"''''''+;
,I .1 ..... '.,b" .... I ..................... - -....... - -_ _ _ _ _ _ _ - _ _ _ _ _ _ - . . . . . _ _ _ _ _ _ _ - -_ _ _ _ . . . _ _ _
.....1