Subaru 1600 Service Manual page 514

NOTE:
If a hose is twisted at this step, the
hose may come into contact with
some other parts.
(For more details, refer to the section
regarding fluid line.)
3) Insert engine oil level gauge into
its hole.
4) Install stay by tightening bolt.
A18·362
Fig. 11-130
NOTE:
The side surface of stay and that of
tank shell should contact with each
other when installing.
5) Fix air cleaner in position.
6) Connect electric wirings and hoses
to air cleaner and hold them by con-
nectors or clips.
7) Set oil pump belt and adjust its
tension, and then fit idler cap.
STEERING SYSTEM
. . 98N
(10 kg, 22 Ib)
A18·200
Fig. 11-131
NOTE:
Make sure to fit idler cap properly by
turning it.
8) Tighten flare nuts of piping to the
specified torque.
Torque
(Flare nuts)
Fig. 11-132
16 - 20 N·m
(1.6 - 2.0 kg-m,
12 - 14 ft-lb)
oj
A 18,151
11-41
9) Connect minus terminal of bat-
tery, and fix spare tire and carburetor
shield in position.
10)
Feed the specified fluid and
discharge air. (For details, refer to the
section regarding fluid line.)
NOTE:
Never start the engine before feeding
the fluid; otherwise vane pump might
be seized up.
11)
Jack up vehicle again and take
out safety stands, and then lower
vehicle.
12) Check the fluid leakage at flare
nuts after turning steering wheel from
lock to lock with engine running.
13)
Tighten bolts to fix both jack-
up plate and clamps for piping.
A18·355
Fig. 11-133
NOTE:
Make sure to hold piping properly by
the clamps.
14) Adjust the fluid level in the
reservoir. (For m;:>re details, refer to
the section regarding fluid line.)