Subaru 1600 Service Manual page 34

.";..~
I "
,
)
.
..:.~ . ..-.
'"
PERIODIC MAINTENANCE SERVICES
Torque N·m (kg-m, ft-Ib)
Nut
A
44 - 54
(one)
(4.5 - 5.5, 33 - 40)
Bolt B
44 - 54
(two)
(4.5 - 5.5,33 - 40)
Bolt C
25 - 34
(three)
(2.5 - 3.5, 18 - 25)
Nut 0 49 - 59
(one)
(5.0 - 6.0, 36 - 43)
Bolt E
14 - 18
(four)
(l.4 - 1.8,10 - 13)
30. Suspension
System,
1) Jack up the front end of vehicle,
and remove front wheels.
2) Remove cotter pin and castle nut
from ball stud and disengage ball stud
from transverse link.
1(1
j, /
:r~
-~
I ' \
j£1
,,",,,
"
LI I,
~r
»
~-:J~
,~ )~
Fig. 2-66
A3·136
3) Remove bolts which secure
housing to ball joint, and remove ball
joint.
4) Check the axial play of ball stud.
If play exists, replace ball joint with a
newone.
5) Check rubber boot for cracks or
damage.
If necessary, replace ball joint.
6) Tighten nuts and bolts which are
used to secure ball joint, to the
specified torque setting indicated in
the chart below.
Torque N·m (kg-m, ft-lb)
Ball stud transverse
39
link castle nut
(4.0, 29)
Ball joint to
29 - 39
(3.0 - 4.0,
housing bolt
22 - 29)
NOTE:
Be careful not to allow the tapered
area of the ball stud to come in
contact with grease.
7) Check the tightness of strut
mounting nuts on front suspension
and retighten the nuts to the specified
torque.
Torque
N·m (kg-m, ft-lb)
Fig. 2 - 67
59 -74
(6.0 - 7.5,
43 - 54)
A3-279
8) Check the tightness of rear cross-
member installing bolts on rear sus-
pension and Tighten the bolts to the
specified torque.
Torque
N·m (kg-m, ft-Ib)
118 - 147
(l2.0 - 15.0,
87 - 108)
31. Grease on Front
and Rear Wheel
Bearinas
Inspect the condition and the amount
of front and rear wheel bearing grease
as follows.
2-20
• Front wheel bearing
1) Raise front wheel with a jack, and
remove wheel. Remove cotter pin
from axle shaft and remove castle nut.
2) Remove bolts which secure disc
rotor to front wheel hub, and remove
hub.
A3·137
Fig. 2 - 68
3) Remove oil seal from housing, and
check the condition of bearing grease.
NOTE:
a. If either the grease appears to be
white or if only a small amount of
grease remains, remove the bearing
from the housing, clean it, and pack
it with grease.
Refer to "SUSPENSION, WHEELS
AND AXLES" for further details.
b. Discard the old seal and install a
new one.
A3·158
Fig.
2 - 69
4) Installation is in the reverse order
of removal.
Torque
(Castle nut)
196 N·m
(20 kg-m, 145 ft-lb)