Subaru 1600 Service Manual page 608

2. Side Window on Hatchback
n
1 Side' window glass
2 Hinge plate
3 Flange screw
4 Nut plate
S
Packing
6
Rosette
Fig. 14-20 Component parts
1) Adjustment of Glass Position
1) Adjusting measures
a. Shifting glass position is made by
loosening screws fixing hinges and/
or lock to the body.
b. Rotation of the glass in the vertical
plane is made by loosening screws
fixing the glass to the hinge and/or
lock.
2) Measuring points of gap.
BODY
7 Screw
8
Hinge cover
9
Lock
1 _~oof side rail
2 Roof
3 Drip rail moulding
A24-428
A24-436
Fig. 14-23 Cross section of B -
A24-434
Fig. 14-21 Measuring points of gap
Unit: mm (in)
A24-435
Fig. 14-22 Cross section of A -
A24-437
Fig. 14-24 Cross section of C -
14-13
Out In
7.8±2mm
c.--
(0.307
±
0.08 in)
Rear Quarter panel
A24-438
Fig. 14-25 Cross section of D -
2) Removal
I) Detach hinge covers by prying
them off with screwdriver.
2) With the glass opened halfway,
remove two screws fixing lock.
3) Remove hinge set screws.
NOTE:
Although the glass won't fall in this
state (in stoppage), remove glass by
holding it with one hand so that the
glass does not fall accidentally.
4) Carefully move the glass to the
outside and take it out from the rear.
A24-432
Fig. 14-26 Removing side window
glass
5) Remove hinge plates and lock as-
sembly from the glass after placing it
on a rag, mat or the like so as to
protect it from damage.
6) Remove weatherstrip from flange
of body.
3) Installation
1) Install weatherstrip as follows.
a. First fit the rear lower corner of
weatherstrip down to the bottom
so that it mates properly to the
recess in the body.