Subaru 1600 Service Manual page 155

4· 7. Fuel Separator
1. Sedan and Hardtop
1) Removal
1) Detach back rest of rear seat and
rear quarter trim.
2) Remove fuel separator installing
screw from rear bulkhead side.
3) Remove screws and nut installing
fuel separator in trunk room.
4) Disconnect air·breather hoses
under rear floor.
5) Bend the joining portion of cover
and protector toward first the center
of vehicle and then its rear while re-
moving separator from floor.
6) Remove screw securing band to
separator, then disconnect hose be-
tween separator and pipe.
7) Take out separator by expanding
the band.
NOTE:
Be
careful not to damage separator
nozzle.
2)
Installation
1) Connect hoses between separator
and pipe, and fit band to separator.
NOTE:
a. The .hoses should be inserted into
separator nozzles until they reach
the bases of separator nozzles.
The hose small end should be
inserted approx. 15 mm (0.59 in)
into pipe.
The hose large end should be
inserted approx. 25 mm (0.98 in)
into pipe.
b. Connect the "L-bend" small hose
between separator upper noule
and the pipe situated in front of
large pipe.
:;g.
4-93
Connecting hoses
A21·089
FUEL SYSTEM
c. Before installing band on separator
I
insert "L·bend" small hose pro·
jected from separator upper nozzle
into concave portion at the corner
of separator.
2) Connect air-breather hoses to pipe
under rear floor.
3) Install separator onto body with
cover and protector.
NOTE:
Ensure to tighten fuel separator instal·
ling screw from rear bulk-head side.
1 Screw A 3 Screw C
2 Nut B 4 Screw D
A21'087
Fig.
4-94
4) Attach rear quarter trim and back
rest of rear seat as before.
2. Hatchback
1) Removal
1) Detach rear trim and rear quarter
trim.
2) Disconnect hoses from separator.
3) Remove separator from body.
4) Remove screw securing band to
separator, and take out separator by
expanding the band.
NOTE:
Be careful not to damage separator
noule.
5) Disconnect air-breather hoses
under rear floor.
6) Remove two screws securing pipe
assembly to floor, and pull it out while
inclining it rearwards.
A21'092
Fig. 4-95 Removing pipe compl
NOTE:
Be careful not to damage pipe ends.
2)
Installation
I) Attach pipe assembly with 2
screws.
2) Connect air-breather hoses to pipe
assembly under rear floor.
3) Fit band onto separator with
screw.
4) Install separator in position with 2
screws.
1 Separator
2 Screws
Fig.
4-96
A21-091
5) Connect hoses to separator.
NOTE:
a. Connect hoses to separator and
pipes as before .
b. The hoses should
be
inserted into
separator nozzles until they reach
the bases of separator noules. The
hoses should be inserted approx.
15 mm (0.59 in) into pipes.
6) Attach rear trim and rear quarter
trim as before.