Subaru 1600 Service Manual page 639

1. Removal
1) (except 4WD) Detach bumper
cover.
2) Remove bumper side
B.
3) Remove bolts and nuts attaching
dampers (or stays) to body, and then
take out bumper center along with
dampers (or stays).
4) Separate dampers (or stays) and
bumper side A from bumper center.
NOTE:
a. Since the damper is filled with high
pressure gas, never put it in fire nor
disassemble it
b. Since bumper side is made of soft
plastic, be careful not to scratch it
2. Installation
1) Attach dampers ( or stays) and
bumper side A to bumper center.
Torque
Damper pin
and nut
BODY
47 -71 N·m
(4.8 - 7.2 kg-m,
35 - 52 ft-Ib)
2) Install bumper center onto body
with bolts and nuts.
Torque
Damper pin
and nut
jU
Fig. 14-144
16 - 27 N·m
(1.6 - 2.8 kg-m,
12 - 20 ft-lb)
A24-334
3) Install bumper 'side B with bolts
and nuts.
14-44
A24·333
Fig. 14-145
4) Attach bumper cover with two
flange nuts in trunk room, and with
two clips fixing it to bumper side.
(except 4WD)
A24-332
Fig. 14-146
I, I I 'O"'~
..
"""~'_'_lt"
_ _ _ """""' _ _
""I""_I_'
"I_I~
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _