Subaru 1600 Service Manual page 483

3) Install the horn brush.
NOTE:
a. Check brush for deformation.
b. Install brush without fail because
it is ground connection for horn
circuit.
4) Install the combination switch
and column covers (upper & lower) to
the steering column.
5) Install the steering wheel to the
steering shaft.
Torque
(Steering
wheel)
29 - 39 N·m
(3.0 - 4.0 kg-m,
22 - 29 ft-lb)
6) Check clearance between the
steering wheel and the column cover.
Clearance
1- 3mm
(0.04 - 0.12 in)
If the clearance is not in the specified
range, loosen column cover installing
screws and adjust column cover.
Clearance:
1 - 3 mm (0.04 - 0.12 in)
A1S-096
Fig. 11-13 Checking clearance
7) In 2-spoke type steering wheel,
install horn pad to steering wheel and
tighten screw securely from the back
side of steering wheel.
In 2-spoke soft type steering wheel;
a. Align fin part of pad with lower
cover front end, then depressing
(-.1) slightly, pull (-.2) pad so that
hook meets with insert.
b. Aligning pad and lower cover later-
ally, depress boss parts (a & b in
Fig. 11-7) of pad so as to clip into
lower cover.
NOTE:
After installation of pad, check horn
by depressing horn mark of pad.
STEERING SYSTEM
Fin part of pad Pad assy
~:~]Y
Lower Hook
cover
A18-374
Fig. 11-14 Installing pad
(2-spoke soft type steering
wheel)
(Power steering) CD
(Manual steering)
®
6. Installation
1) Insert the end of the steering
shaft assembly into the universal joint
through the grommet of the toe board.
2) Tighten the steering shaft install-
ing bolts under instrument pannel.
Torque
20 - 31 N·m
(2.0 - 3.2 kg-m,
14 - 23 ft-lb)
1 Universal joint tightening bolt
2 Torque rod
3 Pinion
4 Gearbox
5 D.OJ.
6 Toe board
7 Steering shaft installing bolts
*
Clearance 9.5 mm (0.374 in)
(Manual transmission vehicle)
16.5 mm (0.650 in)
(Automatic transmission vehicle)
A1S-345
Fig. 11-15 Installation of steering shaft
3) Connect connector for ignition-
starter switch and combination switch
wiring harness under instrument pan-
ne!.
4) Tighten the universal joint bolt.
Torque
(Universal
joint bolt)
NOTE:
22 - 25 N'm
(2.2 - 2.6 kg-m,
16-19ft-Ib)
a. Confirm that the bolt is aligned
with the notch on the steering shaft
serration.
11-10
b. Make sure to insert bolt and washer
from the recession of universal
joint.
A1S-055
Fig. 11-16 Tightening universal joint
bolt
. - ~ - " " · " 4 ~ ' _ ' ~ _ " ' "
.... , . . , , - -........ , - , ................... ' ................ , ... 1· .....
.,..1 _ .. t .... , _ _ _ _ _ _ _ _ , ""' _ _ _ _ _ _ _ _ _ _ - ....... , _ , _ _ _ _ , _ , _ _ _ -