Subaru 1600 Service Manual page 364

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
4) Remove the jack from under-
neath the transmission.
5) Clamp the parking brake cable to
the body.
• Tightening torque for cable cover:
Torque
3 - 6 N·m
(0.3 - 0.6 kg-m,
2.2 - 4.3 ft-lb)
6) Align the spring pin holes on the
axle shaft and drive shaft, and drive
the spring pin into the holes.
NOTE:
Always install a new spring pin.
A15·015
Fig. 7-181 Installing axle shaft
7) Using a screwdriver, properly align
the bolt holes on both the left and
right transverse links with the cross-
member, and insert the bolts into the
holes from the front side. Tighten
the nuts securely.
NOTE:
a. Always use new nuts.
b. Tighten the nuts to the specified
torque after finishing all work and
lowering the car to the floor.
Torque
59 - 69 N·m
(6.0 - 7.0 kg-m,
43 - 51 ft-Ib)
A4·128
Fig. 7-182 Installing transverse link
8) Install the stabilizer.
Be sure to position the two center
bushings with their slits facing the rear
side of the car and the two outer
bushings with their slits facing the
inside.
Torque
18 - 22 N·m
(1.8 - 2.2 kg-m,
13-16ft-Ib)
A4-125
A4-126
Fig. 7-183 Installing stabilizer
9) Move the select lever to the "P"
position, insert the linkage rod into
the manual lever, set the select lever at
"N" position, and then tighten the
nut.
Torque
10 - 18 N'm
(1.0 - 1.8 kg-m,
7 - 13 ft-Ib)
7-69
A4·144
Fig. 7-184 Connecting linkage
A4-120
Fig. 7-185 Installing oil supply pipe
11) Install the front exhaust pipe
ASSY as follows:
a. Position the exhaust pipe on the
bracket on the car body, and secure
it with the bolts.
b. Install a new gasket to the exhaust
port of the engine, and temporarily
tighten the exhaust pipe retaining
nuts.
c. Temporarily tighten the front and
rear exhaust pipes with the new
gasket in place.
d. After making sure that the exhaust
pipe ASSY is properly positioned,
re-tighten the bolts and nuts
securely.
Torque
Front exhaust pipe to engine:
25 - 29 N·m
(2.6 - 3.0 kg-m, 19 - 22 ft-Ib)
Front exhaust pipe to rear
exhaust pipe:
42-52N·m
(4.3 - 5.3 kg-m, 31- 38 ft-Ib)
Front exhaust pipe to bracket:
25 - 34 N'm
(2.5 - 3.5 kg-m, 18 - 25 ft-Ib)