Subaru 1600 Service Manual page 416

4) Install exhaust pipe (rear) and
muffler in position.
a.
Al1
models except 4WD: Tighten
bolts connecting exhaust pipe (rear)
along with muffler and exhaust
pipe (front), and then connect with
three cushions.
Torque
1 Connecting bolt
2 Cushion
Fig. 9-52
42 - 52 N·m
(4.3 - 5.3 kg-m,
31-38ft-Ib)
A15-ll2
b. 4WD: Tighten bolts connecting
exhaust pipe (rear) and exhaust
pipe (front), and exhaust pipe (rear)
and muffler.
Then connect with three cushions.
Torque
42 - 52 N·m
(4.3 - 5.3 kg-m,
31 - 38 ft-Ib)
5) (4WD only) Install rear differential
as follows.
a. Set rear differential in position with
a jack, and tighten the four nuts.
Torque
Fig. 9-53
69 -78 N·m
(7.0 - 8.0 kg-m,
51-58ft-lb)
A1S-lll
SUSPENSION, WHEELS AND AXLES
b. Connect rear differential mounting
member to body.
Torque
(Self-locking
nut)
Fig. 9-54
69 -78 N·m
(7.0 - 8.0 kg-m,
51-58ft-Ib)
A15-ll0
c. Insert propeller shaft carefully in to
rear end of transmission.
d. Instal1 propel1er shaft onto rear
differential.
Torque
Fig. 9-55
18-25N·m
(I.8 - 2.5 kg-m,
13 - 18 ft-Ib)
A4-123
e. Insert rear drive shafts on both
sides onto rear axle spindle and rear
differential.
Fig. 9-56
A15-l09
9-21
f.
Drive spring pins in at both ends of
drive shaft gradual1y by using 6 mm
(0.24 in) dia. steel bar.
A15-l08
Fig. 9-57
6) Install front tires and wheels by
temporarily tightening wheel nuts.
7) Lower vehicle after taking out
safety stands (rigid racks).
8) Tighten wheel nut firmly.
Torque
78-98N·m
(8.0- 10.0 kg-m,
58 -72 ft-Ib)
9) Connect shock absorber upper
end to body on each side with vehicle
unloaded.
Torque
Fig. 9-58
88 - 127 N·m
(9.0 - 13.0 kg-m,
65 - 94 ft-Ib)
A15-l07
10) Tighten outer bushing lock bolts
with vehicle unloaded.
Torque
31-39N·m
(3.2 - 4.0 kg-m,
23 - 29 ft-Ib)