Subaru 1600 Service Manual page 277

MANUAL TRANSMISSION AND DIFFERENTIAL
7) Using a screwdriver, properly align
the bolt holes on both left and right
transverse links with crossmember, and
insert bolts into the holes from the
front side. Tighten nuts securely.
NOTE:
a. Always use new nuts.
b. Tillhten the nuts to the specified
torque after finishing all work and
lowering the car to the floor.
Torque
59 - 69 N'm
(6.0 - 7.0 kg-m,
43 - 5 I ft.lb)
\
~
A4-128
Fig. 6·206 Installing transverse link
8) Install stabilizer.
Be sure to position two center bush·
ings with their slits facing the rear side
of car and two outer bushings with
their slits facing the inside.
Torque
18 - 22N·m
(1.8
2.2
kg·m,
13-16ft.lb)
A4-t25
Fig.6·207 Installing stabilizer
9) Install the gearshift system on
transmission. (except 4WD)
Torque
NOTE:
I
14- 22 N·m
(1.4 - 2.2 kg·m,
10 - 16 ft·lb)
Always use new self-locking nuts.
A4-14!5
A4·140
Fig. 6·208 Connecting gearshift
system
10) On 4WD, remove drive shaft cap,
install propeller shaft, and then
securely tighten differential gear flange
using bolts and nuts.
Torque
18 - 25 N·m
(1.8 2.5 kg·m,
13 - 18 ft-Ib)
A4·123
Fig. 6·209 Installing propeller shaft
6-60
11) Install front exhaust pipe ASSY
as follows:
a. Position exhaust pipe on bracket on
car body, and secure it with bolts.
b. Install a new gasket to the exhaust
port of engine, and temporarily
tighten exhaust pipe retaining nuts.
c. Temporarily tighten front and rear
exhaust pipes with new ga&ket in
place.
d. After making sure that exhaust pipe
ASSY is properly pOSitioned, re-
tighten bolts and nuts securely.
Torque
Front exhaust pipe to engine:
25 - 29N·m
(2.6 3.0 kg·m, 19 - 22 ft·lb)
Front exhaust pipe to rear ex·
haust pipe:
42 52 N·m
(4.3 - 5.3 kg·m, 31 - 38 ft·lb)
Front exhaust pipe to bracket:
*4WD 25 34 N·m
(2.5 - 3.5 kg·m, 18 - 25 ft·lb)
*Non-4WD (10 - 18 N·m
(1.0 1.8 kg-m, 7 - 13 ft-lb)
NOTE:
Be careful not to strike the oXYlJ8n
sensor against any adjacent parts
durinll installation.
A40093
Fig. 6·210
12) Securely connect O
2
sensor har·
ness to O
2
sensor and clamp it.
13) Connect hot air intake hose.
14) Lower car body to the floor.
15) Tighten bolts and nuts which
retain engine to transmission to the
specified torque. Also install starter.
Torque
46 - 54 N·m
(4.7 - 5.5 kg·m.
34 - 40 ft-lb)