Subaru 1600 Service Manual page 695

6) Remove the breaker plate by
removing t\\·o screws.
7) Drill the end of staked straight
pin, then tap out straight pin and
remove the pinion.
NOTE:
When removing the pinion, replace the
pinion and straight pin with new one.
I
f-
ELECTRICAL SYSTEM
Fig. 15-101
11) Disassemble two governor weights
by removing t_wo snap ring clips.
Remove a screw a.nd disassemble reluc-
tor from the distributoLshaft.
2. Inspection
Inspect the following items.
1) Inspect the O-ring on the distribu-
A9-325 '
tor housing for damage.
Fig. 15-99
8) Remove the shaft and governor
assembly from housing.
NOTE:
When removing the shaft from hous-
ing, tap the end of governor shaft
lightly by a plastic hammer if neces-
sary.
9) Governor spring by using a long
nose pliers.
NOTE:
Do not extend the spring too much.
A9-137
Fig. 15-100
10) Remove the cam cap and disas-
semble the reluctor from the distribu-
tor shaft by removing a screw.
Disassemble two governor weights.
i
I
, I ,
2) Inspect the governor springs for
wear and damage.
3)
Inspect diaphragm in the vacuum
controller for breakage.
A9-382
Fig. 15-102
4) Inspect cap and rotor for crack,
damage, corrosion, erosion and spring
action of carbon point.
Carbon point length
Standard
I
12 mm (0.47 in)
A9-112
Fig. 15-103
15-32
I I , ",I
I'
!,
3. Assembly
Assembly is the reverse of disassem-
bly, however, when assembling the dis-
tributor, pay attention to the follow-
ing items.
1) Reluctor
When assembling the cam, match
the "11.0" mark on the plate and
stopper through the hole in the dis-
tributor shaft.
NOTE:
Pack distributor grease into inside of
the reluctor.
A9-428
Fig. 15-104
2) Governor
When installing the shaft and gover-
nor assembly in the housing, coat en-
gine oil on the shaft.
A9-326
Fig. 15-105
3) Pinion
When installing the pinion, adjust
the clearance between housing and
pinion to specified value with the
thrust washers.