Subaru 1600 Service Manual page 370

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
b. At the position where the
selec~or
lever is shifted in the "N" range
and pushed to the "P" side lightly,
match the locator to bracket hole,
the moving plate pin to arm hole,
then tighten the bolts to the
specified torque.
Torque
p
Front
...
\
\
1 Locltor
2
Movilll plate pin
4- 8 N'm
(0.4 - 0.8 kg·m,
2.9 -
5.8
ft·lb)
N PUlh IIlIhtlV to
"P" pOlltlon
.r-""'Oo<..-,.o
--r-'@
3 Sprinl pin position
4 Guide pllte
AHI·OB.
Fig. '·208
c. Pull out the 2 mm (0.08 in) dia. rod
(knock pin) at the inhibitor switch.
6) Assemble indicator to plate.
Torque
(Flange
screw)
Fig.
'·209
1.3 - 2.6 N'm
(0.13 - 0.27
kg·m,
0.9 - 2.0 ft.lb)
A18·085
7) Assemble the grip, spring and
button to selector lever.
1 Grip
2
Sprlnl
3 Button
A 18·081
Fig.
'·210
a. Apply grease on the sliding part
of the grip and button, and spring.
b. Insert the spring into the but·
ton and insert it into the grip from
the spring side.
c. Insert the grip on the selector
lever while pushing button in the
grip.
d. Set the button to driver's side, then
tighten screws to the speCified tor·
que with the torque driver.
Torque
1.3 - 2.6 N'm
(0.13 - 0.27 kg·m,
0.9 - 2.0
ft·lb)
5 to 6 mm (0.20 to 0.24 in) length
screw should be used.
8) After assembly, inspect the fol·
lowing items by shifting the selector
lever from "P" to "1" range while
pushing the grip button.
• Contact between indicator and
selector lever.
• Matching of the pointer and
position mark.
• Selector lever shifting force.
9) Assemble the following parts to
selector lever.
Fig. '·211
7-75
A18·087
1
Bulhinl
2
Rod
3 Wilber
4 Cotter pin
a. Bushing
Apply grease to the inside and
side surface of bushing.
b.
Rod
c. Washer
d. Cotter pin
After inserting the cotter pin into
rod hole, be sure to bend it.
10)
Screw in one nut fully to the
threaded part of rod.
8. Instanatlon
1)
Install the following parts to
transmission selector arm.
1
Bushinl
2
Connector
3 Wilber
4
Cotter pin
Fig.
'·212
a. Bushing
A111·088
Apply grease to the inside and
side surface of bushing.
b. Connector
Insert the connector from trans·
mission side.
c. Washer
d. Cotter pin
Be sure to bend cotter pin.
2) Pass the rod through connector
and tighten a nut temporarily.
A 111·0811
Fig.
'·213