Subaru 1600 Service Manual page 493

A·18·305
Fig. 11·45 Removing snap ring
(larger one)
10) Pull out the pinion.
11) Pull out the rack from the pin-
ion side of the gearbox unit.
NOTE:
Be careful not to damage the bushing
placed inside.
12) Remove the snap ring (smaller
one) on the pinion with snap ring
pliers.
A18·090
Fig. 11-46 Removing snap ring
(smaller one)
STEERING SYSTEM
13) Remove the ball bearing from
pinion with a press.
NOTE:
Support the depressing force with
inner race of bearing.
Press
A18·091
Fig. 11-47 Removing ball bearing
14) Remove the oil seal and snap
ring (larger one) from pinion.
15) Remove clip from gearbox unit
with a slot screwdriver.
16) Remove bushing A from the end
of gearbox unit by using a aluminum
bar and a hummer.
11-20
Aluminum bar
Bushing A
A18·127
Fig. 11-48
NOTE:
Be careful not to damage inside of
gearbox unit.
"'Ir"'-~'''''''H
...... __ ._ ....... , ....
u_._,_._ . . . . . . . . , . . . . . , . . . . . . ,_,_' . . _ . . . . . .
[1-' ....
'--,."1------..
,1"""-· ... , ... , _ _ _ _ _ _
It _ _ _ .... , _ . _ _ _ _ _ _ _ _