Subaru 1600 Service Manual page 731

8)
Disconnect hoses between washer
nozzles and tank at their connection.
9) Remove bolts installing nozzles,
and take out them.
A25-346
Fig. 15-204 Removing bolts
10) Disconnect electric wires from
washer pump at connector, and take
out tank by pulling up.
2) Installation
For reinstallation, follow the removal
procedure in reverse order with some
cautions as follows.
1) After connecting electric wires
with washer pump, install hose to it.
ELECTRICAL SYSTEM
Fig. 15-205 Installing hose
2) Install washer nozzle after fitting
projection to hole to pravent it from
rotating.
I Hole
2 PrOjection
A25-349
Fig. 15-206 Installing washer nozzle
15-68
3) Use bolts of 16 mm (0.63 in)
length to prevent them from stricking
connecting rod when installing wiper
motor.
4) Install wiper arms with specified
tightening torque.
Tightening
torque
4.4 - 7.4
N·m
(0.45 - 0.75 kg-m,
3.3 - 5.4 ft-Ib)
5) Install wiper arms after turning
ignition-starter switch to "ON" for a
while to set them in the not:mal posi-
tion.
6) On driver's side, use the arm with
red marking that distiguishes from one
for the other side.
A2S-350
Fig. 15-207 Red marking
.... ' r