Subaru 1600 Service Manual page 346

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
Gauge Indication Part No.
1 493210110
Between 1 and 3 493210111
3 493210112
Between 3 and 5 493210113
5 493210114
Install the vacuum diaphragm together
with the selected rod.
NOTE:
Do not forget to install the "0" ring.
22) Assembling the downshift sole-
noid ASSY.
Install the downshift solenoid ASSY in
the bore on the front side of the trans-
mission case turning it by hand.
NOTE:
Do not forget to install the "0" ring.
23) Assembling the servo apply pipe
and servo release pipe.
Lightly drive the pipes into their
proper positions. Ensure that the
pipes' height (at points where the
pipes are supported by the oil pan)
does not exceed 41 mm (1.61 in) as
measured from the mating surface of
the converter oil pan.
A13·498
Fig. 7-100 Installing the servo apply
pipe
Diaphragm
Dimension "L"
rod length
(Measured)
mm (in) mm (in)
34 ( 1.34) Below 30.5 (1.201)
34.5 (1.358)
30.65 - 31.05
(1.2067 - 1.2224)
35 ( 1.38)
31.15 - 31.55
(1.2264 - 1.2421)
35.5 (1.398)
31.65 - 32.05
(1.2461 - 1.2618)
36 ( 1.42) Above 32.05 (1.2618)
NOTE:
a. Be careful not to deform or bend
the pipe.
b. Insta" new pipes at each assembly.
24) Installing the converter oil pan.
Before installing the oil pan, be sure to
clean the oil from the mating surface
of the oil pan and gasket.
NOTE:
Install a new gasket at each assemblv.
Tightening
torque of
converter
oil pan
3.4 - 4.4 N'm
(0.35 - 0.45 kg-m,
2.5 - 3.3 ft-lb)
6 TRANSMISSION
COMPONENTS
The transmission section contains
many small parts which are similar in
configuration and are machined ac-
curately. Before assembling and/or
installing these parts, place them in
neat order so that they may be as-
sembled properly to their proper
positions. Be sure to check the opera-
tion of parts.
7-51
1) Reverse Clutch
Reverse
clutch
drum
®
Piston
I Snap ring
2 Retaining
plate
3 Drive plate
4 Driven plate
5 Dish plate
6 Snap ring
7 Spring
retainer
8 Coil spring
9
Check ball
A13-093
Fig. 7-101 Sectional view of reverse
clutch
I) Disassembly
Pry off the snap ring
CD
with a screw·
driver, and remove the retaining plate
®,
drive plates
@, driven plates (1),
and dish plate
(5).
Using Clutch Spring
Compressor (398673600) and Pliers
(399893600), pry off the snap ring
®
from the coil spring retainer (J).
Remove the coil spring retainer
(j)
and coil springs
CID.
Apply air into the
oil hole to remove the piston.
A13-094
Pliers (399893600)
Compressor (398673600)
Fig. 7-102 Removing snap ring
Fig. 7-103