Subaru 1600 Service Manual page 555

HEATING, VENTILATING AND AIR-CONDITIONING SYSTEM
3) Connect rod between left and
right defroster shutters with clamp.
1 Rod
2
Clamp
Fig. 13-25
A23·066
4) Attach water cock.
5) Install heater unit on body.
Bolts
Fig. 13-26
6) Install defroster nozzles on both
sides.
Fig. 13-27
7) Attach heater ducts between heat-
er unit and blower assembly.
8) Install luggage shelf and instru-
ment panel on body.
9) Attach radio box or console box.
10) Fit heater hose grommet onto
bulkhead.
11) Connect both inlet and outlet
hoses with heater pipe.
A23·049
Fig. 13-28
12) Fill radiator with coolant.
13) Connect ground cable to battery.
2) Water Cock
Removal
1) Follow the same procedures 1) to
4) for "Heater Unit".
2) Remove left defroster duct from
heater unit.
3) Detach water cock cover.
4) Disconnect water cock rod from
plastic clamp at lever A.
5) Remove both inlet and outlet
hose clamps.
NOTE:
Outlet hose clamp can be removed by
twisting cotter pin counterclockwise.
6) Remove water cock by pulling it
up forward.
Installation
1) Install water cock with three
screws.
A23-131
Fig. 13-29
2) Connect both inlet and outlet
hoses with clamps.
13-10
1 Inlet hose clamp
2
Outlet hose clamp
A23-058
Fig. 13·30
3) Set both levers A and E to COLD
position, and connect water cock rod
with plastic clamp at lever A.
®®r@
CD ,/" (
C~~r
\~~ LJ~
1
Lever
E 3
Clam~--------.J
2 Rod 4 Lever A
A23·134
Fig. 13-31
1 Rod
2
Clamp 3
Lever
A
A23-130
Fig. 13-32
4) Attach water cock cover.
A23-129
Fig. 13-33 Removing water cock
cover