Subaru 1600 Service Manual page 362

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
•
Remover
(399863610)
I Final reduction case
2 Needle bearing
Guide
(398833600)
A13-369
Fig.1- 172 Installation of needle
bearing
10) Oil Seal and Needle Bearing
of Governor Shaft
I) Remove bolts securing governor
sleeve to the case and remove the
governor sleeve.
2) Remove needle bearing and oil
seal with Puller Set (499527000) as
shown in the figure.
CD ®
@ @
\ I
!
I
I / - -
I Nut
2 Needle bearing
3 Oil seal
4 Puller Set (499527000)
A13-326
Fig. 7-173 Removal of needle bearing
and oil seal on governor
shaft
3) Install needle bearing with Puller
Set (499527000) and Installer
(399793600) as shown in the figure.
CD®
Needle bearing
2 Final reduction case
3 Installer (399793600)
4 Puller Set (499527000)
Fig. 7-174
Manufacturer's
A13-327
4) Install oil seal with Puller
Set (499527000) and Installer
(399793600) as shown in the figure,
1 Final reduction case
2 Oil seal
3 Installer (399793600)
4 Puller Set (499527000)
A13-328
Fig. 7-175 Installation of oil seal
5) Install governor sleeve to case and
tighten bolts to the specified torque.
Torque
4- 5 N'm
(0.4 - 0.5 kg-m,
2.9 - 3.6 ft-lb)
NOTE:
a. Make sure to install governor sleeve
into case with its drain hole facing
downward.
b. When installing governor sleeve to
case, be sure to install seal ring.
11) Bushing and Oil Seal in
Converter Housing
1) Remove oil seal from converter
housing with thin minus screwdriver
or the like.
NOTE:
Pay attention not to damage the
contact surface of housing.
2) Remove bushing by using Re-
- placer (498107000) and Handle
(498477000) as shown in the figure .
•
[}--®
Converter housing
2 Handle (498477000)
3 Replacer (498107000)
4
Bushing
Fig. 7-176 Removing bushing
7-67
A13-329
3) Press bushing into housing with
Replacer upsidedown as shown in the
figure.
Press
•
W
1 Converter housing
2 Handle (498477000)
3 Replacer (498107000)
4 Bushing
3
@
Fig. 7-177 Pressing bushing
4) Press oil seal into housing by using
Drift (398437700) as shown in the
figure.
Manufacture's mark side
CD
3
1 Converter housing
2 Drift (398437700) or the equivalent
with 58 to 60 mm (2.28 to 2.36 in)
outer diameter.
3 Oil seal
A 1 3-331
Fig. 7-178 Pressing oil seal
NOTE:
a. When pressing oil seal, be careful
not to incline it.
b. Apply the ATF around the oil seal
lip.
9
ASSEMBLY OF THE
ENTIRE AUTOMATIC
TRANSMISSION
1) Joining the Transmission
Case Section to the Final
___ Reduction Case Section
1) Set the final reduction case sec-
tion with converter housing down-
ward.
2) Clean the mating surfaces of the
cases.
3) After putting Guide (499257100)
on the spline portion of drive pinion
rear end, join the transmission case