Subaru 1600 Service Manual page 393

REAR WHEEL DRIVING SYSTEM (4WD MODEL)
3.
Disassembly
When disassembling or repairing be-
cause of sheer necessity, proceed in
the following order, and never forget
to provide matching marks on the
sleeve yoke, flange yoke, tube, etc_
before disassembly.
1) Remove snap ring with a flat
blade screw driver.
2) Remove bearing race by tapping
the root of yoke with a hammer.
A14-041
Fig.
8-43
Removing bearing race
3) Remove journal from yoke.
NOTE:
Be careful not to damage journal when
pulling it out from yoke.
4. Assembly
1) Assemble in the reverse order of
disassembling and never fail to align
the marks made prior to disassembling.
2) Since this joint is of the main-
tenance-free type, refill new grease
when reassembling.
Selective
snap ring
Al~-094
3) Adjust journal axial play by
selecting proper snap rings. The
opposing snap rings must be of the
same thickness.
Fig.
8-44
Selecting snap rings
5. Installation
1) Reverse removal procedures.
Journal 0.02 mm (0.0008 in)
2) Apply grease to the spline and
outside of the sleeve yoke.
axial play or less
Part No.
622033000
622033010
622033020
622033030
622033040
622033050
622033060
622033070
8-16
Torque
(Flange
yoke to
companion
flange)
Selective snap rings
Thickness mm (in)
2.00 ± 0.01 (0.0787 ± 0.0004)
2.02 ±
om
(0.0795 ± 0.0004)
2.04 ± 0.01 (0.0803 ± 0.0004)
2.06 ± 0.01 (0.0811 ± 0.0004)
2.08 ± 0.01 (0.0819 ± 0.0004)
2.10 ± 0.01 (0.0827 ± 0.0004)
2.12 ± 0.01 (0.0835 ± 0.0004)
2.14 ± 0.01 (0.0843 ± 0.0004)
18-25N·m
(1.8 - 2.5 kg-m,
13 - 18 ft-Ib)
Paint color
White
Yellow
Red
Green
Blue
Light Brown
No paint
Pink