Subaru 1600 Service Manual page 612

2) Removal
NOTE:
a. When removing the parts, carefully
protect the body paint, glass, etc.
from damage.
b. Be careful not to damage trim
panel, sealing cover, etc.
I) Remove rear seat cushion and
back rest.
2) Remove seat belt shoulder anchor.
3) Detach regulator handle.
4) Detach arm rest, rear pillar trim,
upper trim panel and lower trim panel.
5) Remove seat belt retractor, dis·
connect electric connector for door
switch, and then detach sealing cover.
6) Lower side glass fully, and remove
one tapping screw fixing outer
weatherstrip from the inside. Also reo
move two tapping screws fixing grille
from the outside. Lift grille slightly
and pull out outer weatherstrip to the
forward.
7) Close the glass halfway and dis·
connect glass holder from regulator
arm.
NOTE:
Be careful not to drop the nut into
interior of body panel.
8) Remove stopper B and three ad·
juster nuts. Don't remove stopper A
in this step.
NOTE:
It is recommended to put a mark to
recognize its original position.
CD--,--
IJ
1 Regulator handle
2 Stopper B
3 Adjusting nuts
A24-445
Fig. 14-40 Removingstopperand
adjuster nut
BODY
9) Lower regulator arm by turning
regulator handle so as to facilitate reo
moving the side window glass.
10) Lift side window glass up to a
position 10 to 15 em (approx. 5 in)
below the roof, and then remove it
from front opening of the window
together with guide plate by turning it
forward.
A24·446
Fig.
14-41
Removing side window
glass
NOTE:
In this case, keep adjust bolt fully
screwed in the guide plate so as to
facilitate removing side window glass.
However, it is recommended to mark
the set position of the adjust bolt to
make adjustment easy.
11) Remove four bolts fixing regula·
tor, and then take out the regulator
from the work hole.
Fig.
14-42
Removing regulator
3)
Installation
NOTE:
A 24-441
Prior to installation, it is necessary to
check the following items.
14-17
a. Deformation or crack on weather-
stripping.
b. Wear or damage on glass holder
roller.
c. Excessive free play or damage on
the parts of regulator.
d. Lubrication on regulator and guide
plate.
1) Install regulator in pOSition with
four bolts.
Torque
5 -7 N'm
(0.5 - 0.7 kg·ro,
3.6 - 5.1 ft-Ib)
2) Position side window glass along
with guide plate, and tighten the
3
ad-
justing nuts which fix the guide plate.
Torque
NOTE:
18 - 23 N'm
(1.8 - 2.3 kg-m,
13 - 17 ft-lb)
When mounting side window glass in
combination with guide plate, care-
fully protect body paint and glass
from damage. Pay special attention
not to damage the rubber parts of
weatherstripping. Otherwise, water
might leak in.
3) Attach stopper B with bolt and·
washers.
Torque
5 -7 N'm
(0.5 - 0.7 kg·ro,
3.6 - 5.1 ft·lb)
4) Tighten flange nut to connect
regulator ann with glass holder.
Torque
Fig. 14-43
7-9N·m
(0.7 - 0.9 kg·m,
5.1 - 6.5 ft-Ib)
A24·444
------'