Subaru 1600 Service Manual page 626

1 Weatherstrip
2
Glass
Fig. 14-94 Checking (1)
A24-518
2) If whole glass edge is covered by
the lip of weatherstrip with glass
closed all the way.
If not, glass stroke is insufficient.
Make adjustment by shifting upper
stoppers.
Refer to adjustment
®
and
@.
1 Weatherstrip
2 Glass
Fig. 14-95 Checking (2)
A24-519
3) If the gap against the body is
proper. (Pay special attention to the
center pillar side.)
If not, adjust by shifting bolts of front
sash.
Refer to adjustment
© .
4) If the glass won't be inclined upon
fully closed.
If it inclines, the upper stoppers are in
uneven contact.
Make adjustment so as to obtain even
contact.
Refer to adjustment
®
and
@.
5) If the glass is moved properly.
If it moves in letter "8", make adjust-
ment by shifting regulator channel B
up or down.
- - - - - - - - - - - - - - - - - I
/ / / i
A24-520
Fig. 14-96 Checking (5)
BODY
NOTE:
If regulator channel B is adjusted,
upper stoppers should be readjusted,
because even contact of upper stoppers
might be canceled.
Refer to adjustment @.
6) If gap is provided between glass
and roof side weatherstrip upon de-
pressing the glass slightly by hand
from inside of passenger compartment.
If it is, make adjustment by turning
adjust bolts at the bottom of sashes.
Refer to adjustment @-2).
NOTE:
Confirm there is not water leakage
into passenger compartment by pour-
ing water with a hose or shower.
7) If the glass is moved smoothly by
operating regulator handle.
If operating force is too large, ie. more
than 34.3 N (3.5 kg, 7.71b) when
raising, more than 53.9 N (5.5 kg,
12.1 Ib) at end of its stroke, possible
causes are as follows:
a. There is inclination of the bracket
for adjusting top of rear sash.
b. Each bottom of front and rear
sashes is not adjusted uniformly.
c. There is an excessive friction
between the glass and inner weather
strip at top of trim panel.
8) If the glass comes in contact with
the retainer of roof side weatherstrip
upon closing the door.
If it does, make adjustment with refer-
ring to adjustment
®,
®
or
©.
9) If the lip of weatherstrip is en-
gaged into inside of the glass upon
closing door with glass at its upmost
position.
If it is, the glass rises excessively, and
make adjustment with referring adjust-
ment@.
Good
Fig. 14-97 Checking (9)
14-31
No good
A24-521
3. Repair for
Components
• Door
1) Removal and installation of front
door can be carried out by removing/
tightening 8 mm bolts of upper and
lower hinges on door side with Door
Hinge Wrench 925610000.
Torque
(8
mm bolt)
Fig. 14-98
20- 25 N·m
(2.0 - 2.6 kg-m,
14 - 19 ft-Ib)
A24-461
2) With front door open, rear door
can be removed/installed in the same
manner as front door.
3) When remOving/installing door,
jack up the door with rag or wood
block placed at the bottom of door.
A24-462
Fig. 14-99
4) Apply grease to the moving point
of door hinge.
5) Fill inside of grease cap with
grease.