Subaru 1600 Service Manual page 371

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
3) Install selector lever assembly to
the body.
a. Affix butyl rubber tape around the
through hole but inside the four
thread holes.
Fig.
7-214
b. Tighten flange tapping screws.
Torque
4.4 - 7.4 N'm
(0.45 - 0.75 kg-m,
3.3 - 5.4 ft-Ib)
c. Set the selector lever in "N" posi-
tion.
4) Set the transmission selector arm
in UN" position where the center of
connector is aligned with the casted
boss on transmission case.
Transmission case
Casted boss
A19·091
Fig.
7-215
5) Adjust connection of rod with
selector arm as follows.
A19·148
Fig.
7-216
a. While pushing the rod lightly by a
finger [2.0 to 6.9 N (0.2 to 0.7 kg,
0.4 to 1.51b)], set the nut A apart
from the connector by
1 ± 1
mm
(0.04 ± 0.04 in) as shown in the
above illustration.
b. While holding the nut A with a
spanner, tighten the nut
B.
Torque
(Nut)
10 - 18 N·m
(1.0 - 1.8 kg-m,
7 - 13 ft-Ib)
6) After completing installation,
make sure that the lever operates
properly as follows.
a. The lever moves smoothly through
all the positions.
b. In UN" or "D" position of the lever
with the engine stopped, make sure
the operation of the lever according
to the following procedure.
CD
Set the lever to "N" position
while pushing the button.
ell
Take your hand off the lever and
button.
@
Try to move the lever to
"R"
position without pushing the
button, and make sure that the
lever does not move to "R" posi·
tion.
NOTE:
At this time, the select lever spring pin
must be kept at the position of the
guide plate as shown in the following
illustration.
Guide plate
A19-149
Fig.
7-217
@
Proceed to set the lever to "D"
position while pushing the button.
@
Take your hand off the lever and
button.
@)
Try to move the lever to "2"
position without pushing the
NOTE:
At this time, the select lever pin must
be kept at the position of the guide
plate as shown in the following
illustration.
Guide plate
Fig.
7·218
A19-150
7) Connect electric connectors for
inhibitor switch and indicator illumi·
nation light.
Front
•
A19-074
Fig. 7·219
8) Check inhibitor switch operation
as follows_
a. The engine can be started with
selector lever at only "N" or "P"
position.
b. The reverse lamp lights with selec-
tor lever at only "R" position.
c. There must be no position between
"P" and "N" positions wherein
the reverse lamp is lighted, and at
the same time, engine can be
started.
9) Install the console box and the
hand brake cover.
button and make sure that the
Console box
lever does not move to "2" posi-
A19-073
tion.
Fig. 7-220
7-76