Subaru 1600 Service Manual page 422

12) Remove castle nut on axle shaft,
and take out disc and hub assembly.
13) Remove disc cover.
14) Pull housing off axle shaft.
Puller
(921122000)
Fig. 9-70 Removing housing
2. Disassembly
1
Housing
2
on
seal
3 Bearing
4 Spacer
I ,
1
Al.5·164
A16-195
Fig. 9-71 Bearing, spacer and oil seal
1) Move up or down spacer by finger.
2) Apply an aluminum bar or a brass
bar to the inside surface of inner race
of au ter bearing.
Lightly knock the bar by a plastic
hammer to drive bearing out of
housing together with oil seal.
NOTE:
a. Do not knock the bearing by a hard
material, otherwise the bearing will
be damaged.
b. When knocking the bearing, be
care"l, to apply the bar on all
aroun,'the inner race.
SUSPENSION, WHEELS AND AXLES
A16-158
Fig. 9-72 Removing outer bearing
3) Pu II ou t spacer.
4) A pply an aluminum bar or a brass
bar to the inside surface of outer race
of inner bearing.
Lightly knock the bar by a pJastic
hammer to drive bearing out of
housing together with oil seal.
NOTE:
a. When knocking the bearing, be
careful to applv the bar on all
around the outer race.
b. Do not reuse the oil seal.
3. A •• embly
Press is necessary in assembling.
1) Set housing on Die (Installer:
925140000).
2) Set bearing onto Punch (Installer:
925140000) and gradually press it
into housing till outer race of bearing
comes to contact with stopper.
1 Housing
2 Punch
Pre ..
A 16-160
3 Bearing (Outer)
4
Die
Fig. 9-73 Press-in of bearing
9-27
3) Turn upside down housing, and
apply about 10 to 13 g (0.35 to 0.46
oz) of bearing grease into inside of
housing.
4) Insert spacer.
1 Spacer
2 Housing
3' Die
Fig. 9-74 Inserting the spacer
A16-196
5)
The other bearing is pressed in as
shown in figure.
1 Punch
2
3
Fig. 9-75 Press-in of bearing
6) Set housing on Die.
A16-162
Apply sufficient grease on the lip of
the inside of oil seal.
7) Insert oil seal into the groove of
Punch so that the oil seal lip faces the
groove, and gradually press it into
housing till the face of Punch comes to
contact with bearing outer race.
I Punch 3 Housing
2 Oil seal (Outer) 4 Die
Fig. 9-76 Press-in of oil seal
- - , - - - - - _ . -
- - - - -
.---
----~--
---
_ . _ - , - , , _ . _ - - - - - - - - - - - - - -
. ~
1
I