Subaru 1600 Service Manual page 721

, I
• Operation of Turn Signal
Switch
When the switch is actuated with
ignition-starter switch "ON" , both
front and rear turn signal lights and
turn signal indicator lights on com-
bination meter are flashed.
A25-279
Fig.
15-164
Operation
of
turn signal
switch
• Operation of Hazard Warning
Light Switch
While the switch is actuated regardless
of pOSition of ignition-starter switch
by pushing the switch knob, all tum
signal lights and turn signal indicator
lights are flashed.
A25-526
Fig.
15-165
Hazard warning light
switch
II
ELECTRICAL SYSTEM
• Turn Signal and HIZIrd Unit
The unit is a transister type, and is
installed with a screw under the
instrument panel.
(Instrument panel)
A25-784
Fig. 15-766
NOTE:
When handling the unit, lie careful not
to jar it
• Replacement
1) Remove screws installing steering
column, and pull down steering
column.
2) Remove screws from backside of
steering wheel and disconnect electric
wires from horn switch at connector,
and then take out steerinl wheel
cover.
3) Remove nut installing steering
wheel, and take out steering wheel.
"'215-284
Fig.
15-167
Taki", out .r.,.ing
whHI
15-.
I,' "
4) Remove screws installing com-
bination switch and steering column,
and take out steering column cover.
A25-285
Fig.
15-168
Removing screws
5) Disconnect electric wires from the
switch at connector.
A25-785
Fig.
75-169
Disconnecting connector
6) Pull out combination switch, and
replace it.
NOTE:
Be sure to connect electric wire with
horn switch at connector before
installing steering wheel cover.