Opening Engine Hood; Lifting Points And Procedure; Pantograph Jack - Subaru 1600 Service Manual

GENERAL INFORMATION
1-8. Opening Engine Hood
1) Engine hood can be lifted slightly
by pulling engine hood lock release
located at the lower area of instrument
panel.
I
I
I \
OM-S02
Fig. 1-11 Engine hood lock release
2) Push up safety catch with hood
pushed down slightly and unlock it.
OM-S03
Fig.
1·12
Re/68sing hood lock
3) Lift hood and unfasten stay from
holder and put the top of stay into the
stopper on hood.
A1·064
Fig. 1·13 Setting the stay
4) If engine hood needs to be opened
wider than normal position, remove
stay and set it as shown in figure.
1-9. Lifting Points and Procedure·
1. Pantoaraph Jack
• Mark shows each pantograph jack
setting positions.
OM·61S6
Fig. 1-15 Lifting points
NOTE:
I.
Never get under the vehicle while it
is supported only by the jlck.
Always use safety stands to support
body when you have to
get
under
the Clr.
b. Block the wheels dilgonilly by
wheel chocks.
c. Make sure the jack is set at the
correct position on the fllnge of
side sill.
1-10
A4·161
Fig. 1-14 Setting the stay
5) When clOSing engine hood, detach
stay with hood lifted slightly.
Mter setting stay on holder, lower
hood.
Then push down the front end of
hood to lock it.
NOTE:
Make sure thlt the hood is locked
completely before driving.
Fig. 1-16 Settingjack