Subaru 1600 Service Manual page 139

3) Install injector weight, ball and
piston return spring.
NOTE:
Install return spring with its hook
portion facing downward.
1 Ball
2 Piston return spring
3 Injector weight
Fig.
4·32
AB·298
6} Installing Choke Chamber
1) Position choke chamber on float
chamber with gasket between them
and tighten with five screw & washer
assemblies.
NOTE:
a. Tighten the screw near the acceler·
ating pump together with harness
clamp.
b. Run the harnesses for anti·dieseling
switch and for switch vent solenoid
valve above solenoid valve as shown
in the figure.
1 Screw & washer assembly
2 Clamp
Fig.
4·33
A8·289
2) Connect anti·dieseling switch
with 12.2
rom
washer to float cham-
ber.
FUEL SYSTEM
Anti~ieseling
switch -,
Fig.
4·34
AB·288
3) Install return spring of return
f'l
L
Return springlsl
Fig.
4·35
7} Installing Linkage
A8·2B7
1) Install cam connecting rod with
cotter pins and plain washers.
NOTE:
Position the acute angle side of the
connecting rod upward.
1 Cam connecting rod
2 Pump connecting rod
Fig.
4·36
2}
Connect accelerating pump con·
necting rod to pump lever by inserting
the rod end into hole
in
pump lever.
1 Pump lever
2 Pump connecting rod
AB·431
Fig.
4·37
3) Install pump lever with pump
lever shaft, spring, plain washer, and
spring washer.
I Pump lever
2 Pump lever shaft
3 Spring
Fig.
4·38
A8·432
4)
Install throttle return spring.
spring
A8-433
Fig.
4·39
NOTE:
Make sure that all the linkages operate
smoothly.