9) Assemble starter housing and mag·
net switch.
A9·409
Fig. 15·58
10) Tighten two screws in rear frame.
Fig. 15·59
11) Tighten two screws in starter
housing.
Fig. 15-60
12) Tighten two through bolts in
yoke.
A9·412
Fig. 15-61
, I
I
! ",
ELECTRICAL SYSTEM
13) Connect lead wire to magnet
switch.
Fig. 15·62
3) Assembly
• Model: 028000-8570
1) Before
assembling,
completely
clean oil or dust off the surfaces of
both the commutator and brushes.
2)
Apply a sufficient amount of
grease to parts where necessary. (See
Fig. 15· 13 )
3) Install the clutch and idler gear
on the magnetic switch.
NOTE:
a. Be sure to install the steel balls and
spring when installing the clutch.
b. Be sure to apply a sufficient
amount of grease to the roller and
retainer before installing them on
the idler gear.
A9-281
Fig. 15-63 Installing clutch
4)
Install the armature into the yoke.
15-22
II
I
'I
A9-2BO
Fig. 15·64 Installing armature
5)
Install the brush holder on the
yoke, and attach the two brushes to
the brush holder on the yoke side_
6) Put a rubber packing on the
mating surface of the yoke, and
install the yoke with the magnetic
switch.
NOTE:
Be sure to install a felt washer on the
armature shaft bearing.
Fig. 15·65 Attaching yoke
7)
Install the drive gear over the
armature shaft.
A9-277
Fig. 15·66 Installing drive gear
8)
Attach the magnetic switch to the
housing, and secure them with the two
screws.
I I '
,1