Subaru 1600 Service Manual page 423

8)
Turn upside down housing and set
it on Die turned upside down also.
9) Insert oil seal intq the groove of
Punch so that the oil seal lip faces the
groove, and gradually press it into
housing.
1
2 Die
A16-164
Fig. 9-77 Press-in of oil seal
4. InstaUation
1) Fit housing onto axle shaft and
attach spacer of Installer (925130000)
on outer bearing inner race taking care
not to damage the oil seal lip.
Then, connect the rod of Installer
to the thread of axle shaft so that
housing does not drop off from axle
shaft.
2) Install transverse link ball stud to
housing.
Torque
29 - 39 N·m
(3.0 - 4.0 kg-m,
22 - 29 ft-Ib)
Fig. 9-78 Installing transverse link
ball stud
SUSPENSION, WHEELS AND AXLES
3) Turn the handle ,*hile holding the
rod end
by
means
df
spanner, thus
,
housing is pushed in.
I
J
1
A16-166
Fig. 9-79 Installing "qusing
I
4) Connect damper strut and housing
by installing two bolts.
A16-167
Fig. 9-80 Installing ¢lamper strut
Torque
29 - 39 N·m
(3.0 - 4.0 kg-m,
22 - 29 ft-Ib)
5) Connect tie-rod end and housing
knuckle arm.
Torque
(Castle nut)
25 - 29 N·m
(2.5 - 3.0 kg-m,
18 - 22 ft-Ib)
After tightening to the speCified
torque, further tighten castle nut with-
in 60° to align holes of castle nut and
ball stud.
Then insert cotter pin into ball stud
and bend it around castle nut.
6) Install disc cover to housing with
one bolt.
9-28
Torque
6-14N·m
(0.6 - 1.4
kg-m,
4.3 - 10.1 ft-Ib)
7) Install disc and hub ASSY onto
axle shaft.
8) Install brake ASSY to housing by
two bolts.
Torque
49 - 69 N·m
(5.0 -7.0 kg-m,
36 - 51 ft-Ib)
A16-168
Fig. 9-81 Installing brake ASSY
9) Connect hand brake cable to
brake ASSY.
Fig. 9-82
10) Apply hand brake.
11) Fit center piece, conical spring
washer and axle nut in this order onto
front axle shaft and tighten castle nu t
to the speCified torque, then insert a
new cotter pin and bend it around axle
nut.