Calling Number Display-Ccis - NEC NEAX 2000 IPS System Manual

CALLING NUMBER DISPLAY-CCIS

General Description
This feature permits the number of a calling or called party at another switching office to be displayed ei-
term
ther on a D or an Attendant Console.
To transfer the calling party number received from the network (ISDN CPN/Caller-ID/MFC or T1-ANI)
transparently between the offices on the CCIS network, assign the following data.
The calling party number sent from the network over CCIS can be displayed on the LCD of the station of
another office over CCIS, and can be sent to the SMDR. It can be sent to also the MCI, if the system pro-
vides the MCI with ANI.
ISDN CPN/
Caller-ID/
MFC-ANI/
T1-ANI
Programming
START
CM08 Provide the system with the Name Display ser-
vice for Office B.
Provide the system with Caller ID Display fea-
ture for CCIS calls for Office A and B.
Specify the duration of displaying the name
when the incoming call is answered/the select
key for Calling Number Display and Calling
Name Display or CID key is pressed.
[Series 3300 software required]
Specify the duration of displaying the destina-
tion information when the outgoing call is an-
swered by the destination via CCIS.
[Series 3300 software required]
A
Office A
Calling Party Number
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
Office B
CCIS
Transparent
(1) 255
(2) 1 : To provide
(1) 379
(2) 0: To provide
(1) 537
(2) 0 : Until call is finished/key is pressed
again
1 : 6 seconds
(1) 538
(2) 0 : Until call is finished
1 : 6 seconds
– 183 –
CALLING NUMBER DISPLAY-CCIS
Display of
Calling Party
Number on LCD
Sending of
Calling Party
Number to
MCI/SMDR
DATA
NWA-008853-001 Rev.3.0
97ch3002.fm