Timer Class Timer Assignment - NEC Univerge SV8100 Programming Manual

UNIVERGE SV8100
Level:
IN
Description
Use Program 20-31: Timer Class Timer Assignment to assign values to the timers
on a class of service basis.
Input Data
Programming Manual
Program 20 : System Option Setup

20-31 : Timer Class Timer Assignment

Timer Class Number
Item
No.
01
Trunk Queuing Callback Duration Time
Trunk Queuing Callback rings an extension
for this amount of time
02
Callback / Trunk Queuing Cancel Time
The system cancels an extension Callback
or Trunk Queueing request after this amount
of time.
03
Virtual Extension Delay Interval
Virtual Extensions set for Delayed Ringing
(refer to 15-11 : Virtual Extension Delayed
Ring Assignment) ring the extension after
this time.
04
Intercom Interdigits Time (Intercom I/D
Timer)
When placing Intercom calls, extension
users must dial each digit in this time.
05
Trunk Interdigits Time (Trunk I/D Timer)
The system waits for this time to expire
before placing the call in a talk state (Call
Timer starts after time expires, Voice Over
and Barge-In are not allowed until after time
expires).
06
Hotline Time Start Time (Hotline Start)
A Ringdown extension automatically calls
the programmed destination after this time.
Item
0~15
Input Data Default
(sec) (sec)
0~64800 15
0~64800 64800
0~64800 10
0~64800 10
0~64800 10
0~64800 5 (OT)
0 (AU)
Issue 10.1
Related
PRG
20-01-08
20-01-09
20-04-03
21-01-02
21-01-03
21-01-09
2 - 289